Robotic fabrication of high-quality lamellae for aberration-corrected transmission electron microscopy

Hideyo Tsurusawa,Nobuto Nakanishi,Kayoko Kawano,Yiqiang Chen,Brandon Van Leer,Teruyasu Mizoguchi
DOI: https://doi.org/10.48550/arXiv.2102.09698
2021-05-26
Abstract:Aberration-corrected scanning transmission electron microscopy (STEM) is widely used for atomic-level imaging of materials. To accelerate the discovery of new materials based on atomic-level investigations, the throughput of aberration-corrected STEM experiments becomes more and more important. However, the throughput of the full workflow of aberration-corrected STEM is still quite low. A fundamental problem is that the preparation of high-quality thin STEM samples (lamellae) depends on manual operation. Here, inspired by the recent successes of "robot scientists", we demonstrate robotic fabrication of high-quality lamellae by focused-ion-beam (FIB) with full automation software. First, we show that robotic FIB can prepare lamellae with a high success rate, where the robotic FIB controls rough-milling, lift-out, and final-thinning processes. Then, we optimize the FIB parameters of the final-thinning process for single crystal Si. Aberration-corrected STEM imaging of these Si lamellae shows atomic-level images with 55 pm resolution. We also demonstrate robotic fabrication of high-quality lamellae of SrTiO3 and sapphire. The robotic FIB system will resolve the current bottleneck of the full workflow of aberration-corrected STEM analysis and accelerate materials discovery based on atomic-level imaging.
Materials Science,Instrumentation and Detectors
What problem does this paper attempt to address?