Abstract:Abstract Gravity settling represents the main oil-water separation mechanism. Many separation plants rely only on gravity settling with the aid of demulsifiers (direct or reverse breakers) and other chemicals such as water clarifiers if they are required. Yet, other complementary separation methods exist including filtration, flotation, and centrifugation. In terms of results and more specifically with respect to the separated produced-water, the main threshold on its quality is the dispersed oil content. Even with zero discharge and reinjection into hydrocarbon formations, the presence of residual oil in the aqueous phase represents a concern. High oil content results into formation damage and losses in injectivity which necessitates formation stimulations and hence additional operational expenses. In this work, we investigated the effects of different separation techniques on separated water quality. In addition, we studied the impact of enhanced oil recovery (EOR) chemicals on the different separation techniques in terms of efficiency and water quality. Based on the results, we identified potential improvements to the existing separation process. We used synthetic well-characterized emulsions. The emulsions were prepared at the forecast water: oil ratio using dead crude oil and synthetic representative brines with or without the EOR chemicals. To clearly delineate and distinguish the effectiveness of different separation methods, we exacerbated the conditions by preparing very tight emulsions compared with what is observed on site. With that, we investigated three separation techniques: gravity settling, centrifugation, and filtration. First, we used Jar Tests to study gravity settling, then a benchtop centrifuge at two speeds to evaluate centrifugation potential. Finally, for filtration, we tested two options: membrane and deep-bed filtrations. Concerning the water quality, we performed solvent extraction followed by UV analyses to measure the residual oil content as well as light transmission measurements in order to compare the efficiency of different separation methods. The results of analyses suggest that gravity settling was not efficient in removing oil droplets from water. No separation occurred after 20 minutes in every tested condition. However, note that investigated conditions were severe, tighter emulsions are more difficult to separate compared to those currently observed in the actual separation plant. On the other hand, centrifugation significantly improved light transmission through the separated water. Accordingly, we can conclude that the water quality was largely improved by centrifugation even in the presence of EOR chemicals. In terms of filtration, very good water quality was obtained after membrane filtration. However, significant fouling was observed. In the presence of EOR chemicals, filtration lost its effectiveness due to the low interfacial tension with surfactants and water quality became poor. With deep-bed filtration, produced water quality remained good and fouling was no longer observed. However, the benefits from media filtration were annihilated by the presence of EOR chemicals. Based on these results and at least for our case study, we conclude that centrifugation and deep-bed filtration techniques can significantly improve quality of the separated and eventually reinjected water. In terms of the effects of EOR chemicals, the performance of centrifugation is reduced while filtrations are largely impaired by the presence of EOR chemicals. Thereby, integration of any of the two methods in the separation plant will lead to more efficient produced-water reinjection, eliminating formation damage and frequent stimulations. Yet, it is important to note that economics should be further assessed.

Effect of particle size distribution on the dewatering circuit design; case study: iron ore tailing of the Gol-E-Gohar mining and industrial company

Experimental study on inhibition effect of chemical conditioning on low permeability sewage sludge layer under conditions of vacuum preloading

Pilot-scale study on dehydration effect of water hyacinth with different pulverization degree

The Effect of Particle Size, pH, and Flocculant Dosage on the Gel Point, Effective Solid Stress, and Thickener Performance of a Coal-Washing Plant

Designing Paste Thickeners for Copper Flotation Tailings, Using Bed depth Scale-up Factor

Influence of HPGR operating parameters on the edge and centre product – an industrial trial

A study of the microflocculation-multistage filtration technology of mine water containing suspended solids

Performance evaluation of Fe-based water treatment sludge for dewatering of iron ore tailings slurry using coagulation-flocculation process: Optimization through response surface methodology

Electroosmotic Dewatering of Iron Ore Tailings: A Laboratory Study to Improve Geotechnical Properties

Investigating the chamber filling effect on the jaw crusher, cone crusher and HPGR performance

Valorisation of iron ore tailing piles: utilisation of element-to-mineral conversion and association index to building mineralogical modal

Filtration and operational parameters determination of phosphogypsum sludge storage

Consolidation Theory of Slurry Dewatered by Permeable Geotextile Tube with Distributed Prefabricated Drains

Investigating the improvement of the quality of industrial effluents for reuse with added processes: coagulation, flocculation, multi-layer filter and UV

The filterability of different types of minerals and the role of swelling clays in the filtration of oil sands tailings

The filtration of aqueous clay mineral suspension in the presence of bitumen

Effect of filtration rates on the performance and head loss development in granular filters during the post-treatment of anaerobic reactor effluent

FILTER BACKWASH WATER TREATMENT USING DISSOLVED AIR FLOTATION METHOD

Removal of Chlorine, Microparticles and Water from High-Viscosity Liquids by a Sand Filter Coupling Hydrocyclone

Positive pressure filtration of fine-grained materials and analysis of particle size characteristics

Produced Water Quality: The Effects of Different Separation Methods for Water and Chemical Floods