Abstract:ABSTRACT On 8 January 2022, Menyuan County, China, was struck by an Mw 6.6 earthquake that caused surface rupture in the epicentral area and severe damage to an important railway bridge. The earthquake was recorded by only one strong-motion station, which presents a challenge for quantitatively estimating the extent of the ground-motion distribution caused by this event. In this study, the spectral element method (SPECFEM3D code), which solves the elastodynamic equations and can capture the full physics of seismic-wave propagation, is employed for broadband (0–10 Hz) ground-motion simulations of this earthquake. A hybrid kinematic source is developed in which the final slip distribution combines a prescribed asperity model based on Interferometric Synthetic Aperture Radar data (as a source for low-frequency radiation) and a stochastic part (as a source for high-frequency radiation), which introduces spatial heterogeneities to the prescribed asperity model. The numerical approach is first validated by modeling the well-recorded 1994 Northridge earthquake before modeling the Menyuan earthquake. The simulated ground motion is compared with the only observed strong-motion station record, as well as with empirical Next Generation Attenuation-West2 ground-motion models. Then, topography effect in Menyuan earthquake is studied in detail. The simulated ground motions with and without surface topography indicate that the topography tends to focus and scatter the seismic wavefield, resulting in amplification of the ground shaking. The results show a significant correlation between the peak ground velocity (PGV) and topography. The PGV amplification caused by topography effects is period dependent, and its peak amplification reaches up to 50% within a typical resonance period (1–2 s). It could be inferred that the railway bridge probably vibrated in resonance and suffered severe damage owing to the amplified long-period ground motion caused by the topography.

Estimation of model parameters and simulation of earthquake ground motion by stochastic finite-fault modelling based on a modified slip-related corner frequency

Ground motion simulation for the 21 May 2021 Ms 6.4 Yangbi, China, earthquake using stochastic finite-fault method

Ground-motion Simulation Using Stochastic Finite-Fault Method Combined with a Parameter Calibration Process Based on Historical Seismic Data

Stochastic Finite-Fault Modelling of Ms 6.8 Luding Earthquake in 2022 and Seismic Hazard Scenario of Moxi Fault, Southwest China

Stochastic finite-fault modeling of Ms 6.8 Luding earthquake in 2022 and seismic hazard scenario of Moxi fault, southwestern China

Improvement of Stochastic Green's Function Method for 3D Broadband Ground-Motion Simulation

Simulation of Ground Motion From Finite‐Fault Modeling Incorporating the Influence of Duration

Stochastic Green’s Function Method Considering Non-Uniform Rise Time Distribution to Simulate 3D Broadband Ground Motion

Stochastic Finite‐Fault Simulation of the Ms 7.0 Lushan Earthquake Based on Frequency‐ and Distance‐Dependent Radiation Patterns

Improvement of Source Spectrum Fall‐Off for Simulating Ground Motion Using Stochastic Green’s Function Method

Simulation of the 2022 Mw 6.6 Luding, China, earthquake by a stochastic finite-fault model with a nonstationary phase

Regional spectral characteristics, quality factor and site responses in western-central Sichuan, China (II): Application to stochastic ground motion simulation

Ground Motion Simulations for the 19 January 2020 Jiashi, China, Earthquake Using Stochastic Finite‐fault Approach

An updated stochastic finite fault modeling: Application to the M w 6.0 earthquake in Jiashi, China

Estimation of a hybrid slip model and its application to stochastic simulation of the Mw 6.6 earthquake on September 5, 2022, in Luding, China

Parameter estimation for predicting near-fault strong ground motion and its application to Lushan earthquake in China

Modified stochastic finite-fault modelling based on the rupture process: a case study of the 2013 Mw 6.7 Lushan earthquake in China

A Stochastic Method for Simulating Near‐field Seismograms: Application to the 2016 Tottori Earthquake

Probability Density Evolution Method Based Stochastic Simulation of Near-Fault Pulse-Like Ground Motions

Coseismic Deformation Field Extraction and Fault Slip Inversion of the 2021 Yangbi MW 6.1 Earthquake, Yunnan Province, Based on Time-Series InSAR

The 3D Physics-Based Broadband Ground-Motion Simulation, including Topography Effects Causing Damage to Structures, for the 2022 Mw 6.6 Menyuan, China, Earthquake