Frequency-tagging of spatial attention using periliminal flickers

S Ladouce,F Dehais
DOI: https://doi.org/10.1101/2024.02.29.582725
2024-03-04
Abstract:Steady-State Visually Evoked Potentials (SSVEP) manifest as a sustained rhythmic activity that can be observed in surface electroencephalography (EEG) in response to periodic visual stimuli, commonly referred to as flickers. SSVEPs are widely used in fundamental cognitive neuroscience paradigms and Brain-Computer Interfaces (BCI) due to their robust and rapid onset. However, they have drawbacks related to the intrusive saliency of flickering visual stimuli, which may induce eye strain, cognitive fatigue, and biases in visual exploration. Previous findings highlighted the potential of altering features of flicker stimuli to improve user experience. In this study, we propose to reduce the amplitude modulation depth of flickering stimuli down to the individuals’ perceptual visibility threshold (periliminal) and below (subliminal). The stimulus amplitude modulation depth represents the contrast difference between the two alternating states of a flicker. A simple visual attention task where participants responded to the presentation of spatially-cued target stimuli (left and right) was used to assess the validity of such periliminal and subliminal frequency-tagging probes to capture spatial attention. The left and right sides of the screen, where target stimuli were presented, were covered by large flickers (13 and 15 Hz respectively). The amplitude modulation depth of these flickers was manipulated across three conditions: control, periliminal, and subliminal. The latter two levels of flickers amplitude modulation depth were defined through a perceptual visibility threshold protocol on a single-subject basis. Subjective feedback indicated that the use of periliminal and subliminal flickers substantially improved user experience. The present study demonstrates that periliminal and subliminal flickers evoked SSVEP responses that can be used to derive spatial attention in frequency-tagging paradigms. The single-trial classification of attended space (left versus right) based on SSVEP response reached an average accuracy of 81.1% for the periliminal and 58% for the subliminal conditions. These findings reveal the promises held by the application of inconspicuous flickers to both cognitive neuroscience research and BCI development.
Neuroscience
What problem does this paper attempt to address?
This paper mainly discusses how to use close to or below the perceptual threshold flicker stimuli (i.e., subthreshold and near-threshold flicker) to reduce interference in spatial attention frequency tagging, thereby improving user experience. The study found through EEG experiments that although the signal-to-noise ratio of SSVEP (steady-state visual evoked potential) responses below the perceptual threshold is insufficient to reliably distinguish the subject's attention direction, subthreshold and near-threshold flicker can improve the user's comfort with the task, alleviate eye fatigue, and reduce cognitive fatigue caused by flicker stimuli. Furthermore, the study further demonstrates that these weak flickers can be used to capture spatial attention in frequency tagging paradigm, with an average accuracy of 81.1% (near-threshold condition) and 58% (subthreshold condition) in single-trial classification. These findings are of great significance for designing less invasive frequency tagging probes, which are applicable to both basic cognitive neuroscience research and the development of brain-computer interfaces.