Abstract:Impressive improvements in the ability of microfluidic devices to reliably fabricate a wide variety of droplet, capsule, and particle architectures necessitate comparable improvements in techniques to measure and characterize these materials in line. Measurement and control of droplet surface tension are needed to ensure droplet stability while minimizing excess use of surfactants. Standard techniques to measure surface tension typically measure one droplet at a time. Fluidics can be leveraged to measure surface tension in-line with droplet formation. Typically, this requires channel geometries that enable extensional flow. Transient relaxation of deformed droplets is then measured at the exit of a constriction. We propose an alternative approach, in which a single value of steady deformation within a constriction is used to measure surface tension. We flow aqueous droplets in mineral oil through a series of increasingly narrow constrictions and measure steady deformation. In a subset of experiments, droplets contain varying concentrations of polyethylene glycol diacrylate, a common blank-slate hydrogel polymer. We calculate surface tension using Taylor’s small deformation theory, which describes the relationship between steady deformation in shear flows and the Capillary number, the ratio of the applied viscous stress to restoring surface tension stress. We measure surface tension over a wide range of surfactant concentration. Validation using both the transient deformation fluidic approach and pendant droplet measurements demonstrates the viability of our approach. Importantly, our results suggest that steady state measurements of deformation in pressure driven flows provide accurate assessments of surface tension, even when droplets are slightly confined. The use of multiple constrictions allows measurement of hundreds of droplets at several distinct shear rates without the need to vary control parameters. This steady deformation approach represents a readily-accessible option for measuring surface tension of micro-scale droplets in pressure driven flow through rectangular channels.

Direct Measurement of Curvature-Dependent Surface Tension in a Capillary-Condensed Alcohol Nanomeniscus

Temperature- and Curvature-Dependent Surface Tensions and Tolman Lengths for Real Fluids: A Mesoscopic Investigation

Surface Curvature Relation to Protein Adsorption for Carbon-Based Nanomaterials

Molecular droplets vs bubbles: Effect of curvature on surface tension and Tolman length

Measurements of Surface Tension of Organic Solvents Using A Simple Microfabricated Chip

Surface tension measurement and calculation of model biomolecular condensates

Method to Measure Surface Tension of Microdroplets Using Standard AFM Cantilever Tips

Measuring surface tensions of soft solids with huge contact-angle hysteresis

Experimental and Theoretical Investigation of Contact-Angle Variation for Water–ethanol Mixture Droplets on a Low-Surface-energy Solid

Capillary Adhesion at the Nanometer Scale

Droplet deformation in steady fluidic flows enables robust, accessible, high-throughput surface tension measurements

Effect of Surface Roughness and Softness on Water Capillary Adhesion in Apolar Media

Direct Measurement of the Surface Tension of Nanobubbles

Molecular dynamics study on the surface tension of nanoscale aerosol droplets consisted of succinic acid and water

Surface tension of supercooled water nanodroplets from computer simulations

Direct measurement of the capillary condensation time of a water nanobridge

Simulation of Crystal Nuclei at the Liquid-Air Interface Toward Morphology Control Via Surface Tension

Universal deformation of soft substrates near a contact line and the direct measurement of solid surface stresses

Wetting behavior of nanodroplets with low surface tension on pillar-type nanostructured substrates: Molecular dynamics simulations

Curvature Capillary Migration of Microspheres

Substrate curvature dependence of intrinsic contact angles