Abstract:Millimeter-wave (mmWave) frequency bands are attractive for bandwidth (BW)-intensive applications. However, scholarly articles revealing straightforward and repeatable modular construction of mmWave front ends are scarce. Channel sounding, which is critical due to the distinct propagation characteristics of mmWaves, is predominantly done through bulky and expensive laboratory equipment due to the lack of other hardware. This work fills this gap through a modular approach to construct a 60-GHz front-end transceiver by packaging off-the-shelf chipsets and custom-designed blocks. In contrast to the typical expensive manufacturing processes for mmWave circuits, this work reports passive mmWave blocks, which are compatible with single-layer standard printed circuit board (PCB) process along with the measurement setup. Multilayer PCB stack-up is then used for system integration offering an economic and repeatable manufacturing. Distinguishing features of the developed front end are round-trip (half-duplex) communication, carrier reconfigurability within 58–64 GHz, and agent-mode operation. The front end is usable as a portable frequency-domain channel sounder. To the best of the authors' knowledge, it is the first report of a portable channel sounder, which can acquire a round-trip amplitude–frequency response of an mmWave channel without using any bulky or expensive laboratory equipment. This work further identifies the electromagnetic (EM) compatibility issues in unshielded PCBs and hardware response calibration. Furthermore, it identifies the hardware requirements to maintain channel reciprocity in round-trip communication at mmWave bands.

A Wideband Sliding Correlator based Channel Sounder in 65 nm CMOS: An Evaluation Board Design

A Wideband Sliding Correlation Channel Sounder in 65 nm CMOS: Evaluation Board Performance

A Wideband Sliding Correlator-Based Channel Sounder with Synchronization in 65 nm CMOS

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

Millimeter wave and sub-millimeter wave circuits for integrated system-on-a-chip

A 100mhz-2ghz Wireless Receiver In 40-Nm Cmos For Software-Defined Radio

A ${\hbox{70}}{\hbox{–}} {\Hbox{78-}}{\Hbox{ghz}}$ Integrated CMOS Frequency Synthesizer for $W$-Band Satellite Communications

A 0.6V 32.5mw Highly Integrated Receiver for 2.4ghz ISM-Band Applications

A ${\hbox{70}}{\hbox{–}} {\Hbox{78-}}{\Hbox{ghz}}$ Integrated CMOS Frequency Synthesizer for $W$ -Band Satellite Communications

A Flexible Wideband Millimeter-Wave Channel Sounder with Local Area and NLOS to LOS Transition Measurements

A Low-Cost 60-GHz Modular Front-End Design for Channel Sounding

Wideband Channel Measurement and Characterization on a Computer Motherboard

27.5-29.5 GHz Switched Array Sounder for Dynamic Channel Characterization: Design, Implementation and Measurements

A Wideband Distributed Massive MIMO Channel Sounder for Communication and Sensing

Analog Kramers-Kronig W-Band Direct Detection Receiver with 35mw DC Power in 65nm CMOS

A Novel Low-Power Compact WBS Human Body Channel Receiver for Wearable Vital Signal Sensing Application in Wireless Body-Area Network

A Millimeter Wave Digital CMOS Baseband Transceiver for Wireless LAN Applications

A Real-Time Millimeter-Wave Phased Array MIMO Channel Sounder

Real-time Millimeter Wave Omnidirectional Channel Sounder Using Phased Array Antennas

A CMOS Ultra-Wideband Impulse Radio Transceiver for Interchip Wireless Communications

78.8 pJ/b, 100 Mb/s Noncoherent IR-UWB Receiver for Multichannel Neurorecording Implants