Abstract:For low costs, numerical simulation is an effective method to reveal the internal mechanisms inside a thermal plasma torch. Various simulation models for studying the inside or outside characteristics of thermal plasma torches have been built and discussed. However, to reveal the inside mechanisms of thermal plasma torches under various working conditions to support the materials processing, more attention should be paid to building precise models of laminar plasma torches. Thus, based on the user-defined function (UDF) and user-defined scalar (UDS) of ANSYS Fluent software, the assumptions, governing equations, boundary conditions, and solving method were discussed in detail, and a corresponding numerical model of a homemade laminar plasma torch was first built. For verifying the effectiveness of the proposed numerical model and studying the influence of the gas components on the arc characteristics, the working conditions and experimental setups were introduced in sequence. Finally, the numerical and experimental results of the homemade laminar plasma torch were obtained and discussed in detail. The study results show that: 1 The axial temperature of the plasma torch could be divided into three sections along the axis: peak temperature area (10 mm < x < 20 mm), stable temperature area (20 mm < x < 62 mm) and decrease temperature area (62 mm < x < 95 mm). Under the same input conditions, when pure argon gas was used, the peak temperature at the outlet was reached at approximately 7590 K, while for pure nitrogen and 50%Ar + 50%N2, the corresponding peak temperatures were 6785 K and 7402.2 K, respectively. 2 The axial velocity of pure nitrogen is much higher than that of pure argon and 50%Ar + 50%N2, while that of pure argon and 50%Ar + 50%N2 has little difference. In addition, when nitrogen gas was used, the peak velocity at the outlet reached 185 m/s, whereas, for argon gas and 50%Ar + 50%N2, the corresponding peak velocities were 146 m/s and 169 m/s, respectively. 3 The simulated arc voltage trends under different working conditions are well in accordance with the experimental arc voltage trends.

Model of a transition from low to high ablation regime in a carbon arc

A theoretical model considering the photochemical and photothermal behavior of arc radiation-induced gassing materials ablation

Complex structure of the carbon arc discharge for synthesis of nanotubes

Validated two-dimensional modeling of short carbon arcs: Anode and cathode spots

Numerical modeling of CO<sub>2</sub> arc based on the non-chemically equilibrium effect

Investigation of a short argon arc with hot anode. Part I: numerical simulations of non-equilibrium effects in the near-electrode regions

Modeling Arcs

Investigation of the Short Argon Arc with Hot Anode, Part II: Analytical Model

Morphology of Carbon Nanotubes Prepared by Carbon Arc

Carbon-Monoxide Laser Absorption Spectroscopy Measurements over Ablating Graphite in a Shock Tunnel

Modeling of the HiPco process for carbon nanotube production. I. Chemical kinetics

Visualizations of the carbon interphase influence on the ablated fracture morphology of carbon/carbon composites at pore scale

Comparisons Of Kinetic Ablation Models For The Capillary Discharge

Evaluation of Numerical Ablation Model for Charring Composites

Nonequilibrium Ablation of Phenolic Impregnated Carbon Ablator

Numerical analyses of ablative behavior of C/C composite materials

Influence Factors on the Multi-Field Coupling Performances of Charring Ablators on the Basis of a Mesoscopic Ablation Model

Modeling of the Arc Characteristics inside a Thermal Laminar Plasma Torch with Different Gas Components

Modeling ablative behavior and thermal response of carbon/carbon composites

Molecular dynamics study of the short laser pulse ablation: quality and efficiency in production

Discharge dynamics, plasma kinetics and gas flow effect in argon–acetylene discharges