Abstract:The silicon vertex detector (SVD) is a four-layer double-sided strip detector installed at the heart of the Belle II experiment, taking data at the high-luminosity B -Factory SuperKEKB since 2019. SVD has been operating smoothly and reliably, showing a stable and above-99% hit efficiency, and a large signal-to-noise ratio in all sensors. In June 2022 the data-taking of the Belle II experiment was stopped for the Long Shutdown 1, primarily required to complete the vertex detector (VXD) with the inner two-layer DEPFET detector and to upgrade several components of the accelerator. This article reports on the excellent performance of SVD in terms of the signal-to-noise ratio, the hit position resolution, as well as the hit-time resolution. We briefly describe the challenges and delicate phases of the VXD re-installation and the SVD status for operation starting in early 2024. In SVD layer 3, which is closest to the interaction point, the average occupancy has been less 0.5%, well below the estimated limit for acceptable tracking performance. However, higher machine backgrounds are expected at increased luminosity, and so also increased hit occupancy. To enhance the robustness of offline software in a high-background environment, new algorithms of background suppression using the excellent SVD hit-time information have been developed, which allows a significant reduction of the fake rate, while preserving the tracking efficiency. With the increasing luminosity also the radiation levels are expected to increase, with possible deterioration of the sensor performance. The SVD integrated dose is estimated by the correlation of the SVD occupancy with the dose rate measured by the diamonds of the radiation monitor and beam-abort system. The effects of radiation damage are starting and in good agreement with our expectations. So far, no harmful impact due to the radiation damage on the detector performance has been observed.

Diamond detectors for radiation monitoring and beam abort at Belle II

Calibration of diamond detectors for dosimetry in beam-loss monitoring

Recent Advances in Diamond Detectors

CVD Diamonds in the BaBar Radiation Monitoring System

Development and Implementation of Advanced Beam Diagnostic and Abort Systems in SuperKEKB

Validation of the diamond detectors for the Super Fragment Separator beam diagnostics

Silicon Vertex Detector of the Belle II Experiment

Development of the Beam Conditions Monitoring Prime system for beam abort and luminosity monitoring in ATLAS based on a segmented polycrystalline CVD diamond system and dedicated front-end ASIC

The silicon vertex detector of the Belle II experiment

TOP detector for particle identification at Belle II

Diamond and SiC Detectors for Rare Event Searches

Environmental Monitoring for Belle II

Particle identification performance of the prototype Aerogel RICH counter for the Belle II experiment

The Belle II Detector Upgrades Framework Conceptual Design Report

The Belle II Upgrade Program

The Belle II DEPFET vertex detector: current status and future plans

Super KEKB and Belle II: Status of the KEK Super B Factory

The Monitoring System of the End-Cap Calorimeter in the Belle II experiment

Effects of gamma irradiation on DEPFET pixel sensors for the Belle II experiment

Status of Belle II experiment before the first beams