Abstract:Changes in pore pressure within geological reservoirs, due to, for example hydrocarbon production, CO 2 and energy storage or wastewater disposal, may cause substantial stress changes in the overburden, altering propagation velocities of elastic waves. The corresponding time-shifts are detected and quantified using time-lapse (4-D) seismic analysis. To invert seismic time-shifts for changes in stress and strains, stress sensitivity of rocks is studied in laboratory experiments on core plugs. Such measurements are typically conducted at ultrasonic frequencies. However, previous studies indicate that the stress sensitivity of velocities at seismic frequencies could be higher than that at ultrasonic frequencies. Therefore, calibration based on laboratory ultrasonic data may lead to inaccurate prediction of stresses and strains when applied to 4-D seismic data. To study the influence of frequency on stress sensitivity of acoustic wave velocities, a series of laboratory experiments was performed on two overburden shales with different petrophysical properties. In a low-frequency apparatus—a triaxial pressure cell that combines measurements at low (seismic) and high (ultrasonic) frequencies—the shale samples underwent stress changes with different ratios of horizontal to vertical stress amplitudes to mimic stress variations across the overburden. High-frequency velocity changes were directly recorded, while low-frequency velocity changes were obtained indirectly from the elastic parameters measured at seismic frequency by applying a rock physics inversion using third-order elasticity model. The experiments were conducted at undrained conditions, a representative state for reservoir overburden composed of shales. The results suggest that the stress sensitivities and strain sensitivities (R-factor) of P -wave velocities could be two to four times greater at seismic frequencies than at ultrasonic frequencies. Furthermore, it was found that the previously reported linear relation between the stress sensitivity and stress-path parameter (horizontal/vertical stress change) at ultrasonic frequencies also holds for seismic frequencies. We discuss the theoretical background for frequency-dependent stress sensitivity of wave velocities that supports the experimental findings. The effect of frequency when using laboratory-based calibrations should be taken into account when inverting time-lapse seismic data for changes in stresses and strains.

Source Parameters of Laboratory Acoustic Emission Events Estimated From the Coda of Waveforms

Estimating Lab-Quake Source Parameters: Spectral Inversion from a Calibrated Acoustic System

High-resolution source imaging and moment tensor estimation of acoustic emissions during brittle creep of basalt undergoing carbonation

The Relations Between the Corner Frequency, Seismic Moment and Source Dynamic Parameters Derived from the Spontaneous Rupture of a Circular Fault

Equivalent near-field corner frequency analysis of 3D dynamic rupture simulations reveals source complexity

Estimation of the Acoustic Emission Sources Activity Under Mechanical Loading of Materials Based on the Local Dynamic Criterion

Study on Spectrum Characteristics and Clustering of Acoustic Emission Signals from Rock Fracture

Laboratory Shear Behavior of Tensile- and Shear-Induced Fractures in Sandstone: Insights from Acoustic Emission

Stress path dependence of time-lapse seismic effects in shales: experimental comparison at seismic and ultrasonic frequencies

A Novel Method for Estimating Acoustic Emission b Value Using Improved Magnitudes

Noncontacting laser-based acousto-seismics at the laboratory scale: towards near-real-time monitoring of granular analogue models

Temporal‐frequency Distribution and Multi‐fractal Characterization of Acoustic Emission of Rock Materials Containing Two Parallel Pre‐existing Flaws

Cooperative acoustic emission locating with velocity tomography in true triaxial experiment

Aseismic strain localization prior to failure and associated seismicity in crystalline rock

System for Detecting Acoustic Emissions in Multianvil Experiments: Application to Deep Seismicity in the Earth

Acoustic Emission b Value Characteristics of Granite under True Triaxial Stress

The frequency-magnitude relation of microfracturing in rock and its relation to earthquakes

Induced earthquake source parameters, attenuation, and site effects from waveform envelopes in the Fennoscandian Shield

Source mechanisms of deep long period earthquakes beneath the Klyuchevskoy volcanic group (Kamchatka, Russia) inferred from S-to-P amplitude ratios

Revealing the Proximity of Concrete Specimens to Their Critical Damage Level by Exploring the Cumulative Counts of the Acoustic Emissions in the Natural Time Domain

Pre-Failure Strain Localization in Siliclastic Rocks: A Comparative Study of Laboratory and Numerical Approaches