Abstract:A new comparative interferometric method has been developed to measure the thermal conductivity of nanofluids. The thermal conductivity of Al 2 O 3 -water nanofluid is measured relative to deionized water by comparing the steady-state temperature field in the two fluids separated by a conductive barrier using a Mach-Zehnder Interferometer. The method is not restricted to nanofluids and could potentially be used to measure the thermal conductivity of any transparent fluid. Moreover, the method is almost independent of the thermocouple temperature measurement accuracy, with optical errors in the fringe gradients being the primary source of measurement uncertainty. The uncertainty in the relative thermal conductivity measurements is estimated to be ± 6 %. For comparison, the thermal conductivity obtained by this technique is compared to transient hot wire measurements. The reliability of the comparative method is also demonstrated by measuring the thermal conductivity of deionized water. Subsequently, the relative thermal conductivities of Al 2 O 3 -water nanofluids with the concentration of 0.02, 0.05, 0.08, and 0.11 wt% are attained by the two methods at room temperature. This range of concentrations is of interest because anomalously high thermal conductivity has been reported in previous interferometric studies. The results indicate that the thermal conductivity obtained from the comparative interferometric method agrees with the transient hot wire results to better than 2.3 %. Moreover, the thermal conductivity of water-based Al 2 O 3 nanofluids with a weight concentration of less than 0.11 % is the same as deionized water within the uncertainty of the measurement methods.

Application of the Regular Mode Method to the Experimental Determination of Thermal Conductivity of Fluid

An Experimental Determination of Temperature-Dependent Thermal Conductivity of Cyclohexane-Based Nanofluids

Experimental Investigation and Modelling on the Thermal Conductivity of CNTs Based Nanofluids

Experimental study on the thermal conductivity enhancement of water based nanofluids using different types of carbon nanotubes

Measurement of the thermal conductivity of nanofluids using a comparative interferometric method

Thermal-conductivity measurement of nanofluids using 3ω method

MEASUREMENT OF THERMAL CONDUCTIVITIES OF NANOFLUIDS

Statistical analysis of thermal conductivity experimentally measured in water-based nanofluids

A Novel Microsensor for Measuring Thermal Conductivity of Fluid Based on Three Omega Method

Analysis of the 3ω Method for the Measurement of Fluid Thermal Properties

Accurate measurement of thermal conductivity of micro-quantity liquids by dielectric transient current method

Experimental Study on Thermal Conductivity of Water-Based Magnetic Fluid Loaded with Different Nanoparticles

Experimental Study On Thermophysical Properties Of Nanotubes And Nanofluids

Use of a Needle Probe to Measure the Thermal Conductivity of Electrically Conductive Liquids at High Temperatures

A Method for Measuring Thermal Conductivity of Fluids by Using a Small Bead Thermistor.

Short Hot Wire Technique for Measuring Thermal Conductivity and Thermal Diffusivity of Various Materials

Basic nanoconvective flow for transient hot wire experimental method

3 omega method for specific heat and thermal conductivity measurements

Numerical Approach for the Theory of Harmonic Self-Heating Technique to Measure Thermophysical Properties of Suspended Thin Samples

A Switched Vibrating-Hot-wire Method for Measuring the Viscosity and Thermal Conductivity of Liquids

Generalized “slope Method” of the 3ω Analysis to Measure the Thermal Conductivity and Heat Capacity of Solids: Frequency- Vs. Current-sweep