Abstract:Plasma–liquid interaction remains a crucial phenomenon influencing numerous applications. Plasmas produced by electrical discharges exhibit properties that depend on the voltage polarity as well as on the liquid properties. In this study, we investigate the impact of liquid permittivity ( ) and water electrical conductivity ( σ = 2, 500, and 1000 μS/cm) on negative discharges initiated in air at atmospheric pressure. Using a negative pulsed nanosecond high-voltage setup with a pin-to-liquid configuration, experimental results demonstrate that increasing leads to faster discharge ignition and higher discharge current. ICCD imaging reveals a decrease in the maximal radial extension of the discharge over the liquid surface with increasing . Also, rising σ lead to an increase of the discharge current, and the ICCD images show a decrease in the radial propagation of the discharge over the solution. To gain deeper insights into the discharge dynamics and properties, a 2D fluid model is employed to simulate the various conditions. The results indicate that increasing decreases the radial E-field produced by the surface ionization wave and increases the electron density in the air gap. Regarding σ , high-conductivity conditions result in lower radial E-field in the front of the surface ionization wave, explaining the shorter radial propagation of the discharge. Comparing negative with positive discharge, we observe that the former travels a shorter distance over the liquid surface due to its more diffuse front. Moreover, we note the absence of filamentation in the negative surface discharge, unlike the positive counterpart. This disparity is attributed to a relatively lower space charge contained in the front, thereby prohibiting the formation of individual filaments.

Simulation of low-current DC discharges in longitudinal flows of atmospheric-pressure air

Two-dimensional Simulation of a Low-Current Dielectric Barrier Discharge in Atmospheric Helium

Modeling of Flowing Gas Discharge – Part I

Longitudinal structure and plasma parameters of an entire DC glow discharge as obtained using a 1D fluid-based model with non-local ionization

Low-current gliding DC discharge in high-speed flows

Verification and Analysis of Flowing Gas Discharge – Part II

Numerical Simulation of the Voltage–Current Characteristic of an Atmospheric Pressure Discharge: The Glow-to-Arc Transition

Numerical Simulation for Low Pressure DC Argon Glow Discharge

Simulation of Gas Discharge in a Needle-to-Plane Geometry with Hundreds of Micrometers Gap and Its Enlightenment for Direct Charging of Aerosol Particles

Simulation of 1D Atmospheric Pressure Dielectric Barrier Discharge in Argon

Numerical simulation of air DBD under standard atmospheric pressure

Study on Gas Discharge at Atmospheric Air by Numerical Method

One-Dimensional Simulation of Low Pressure Xenon Dielectric Barrier Discharge

Numerical Simulation of Low Current Vacuum Arc Supersonic Flow

Experimental and 2D fluid simulation of a streamer discharge in air over a water surface

Experimental and 2D Fluid Simulation of a Negative Nanosecond Discharge in Air Above a Liquid Surface with Different Dielectric Permittivity and Electrical Conductivity

Simulation Study on the Mechanism of Wire– Cylinder Air Dielectric Barrier Discharge Under Atmospheric Pressure

Dynamics of an Electrical Discharge Initiated by a Powerful Femtosecond Laser Pulse in Atmospheric Pressure Air in Pre-Breakdown Fields

Electrical Model and Experimental Analysis of the Atmospheric-Pressure Homogeneous Dielectric Barrier Discharge in He

On the Impact of a Ring Periodic Surface Barrier Discharge in Air on the Flow Structure

Two-dimension Simulation of Small Scale Dielectric Barrier Discharge in Argon