Abstract:Upon free solidification of a deeply undercooled melt, the solute diffusion in both the interface and the bulk liquid is far from equilibrium, and the concentration and the fluid flow may also play an important role in the solidification. Thus, under such conditions, assumptions about local equilibrium, ideal dilute solution solidification and solidification free of fluid flow can no longer be valid. In the present work, first, in order to reveal the concentration effect, we compared the results of the non-equilibrium dendrite growth models describing the solidification of dilute and non-dilute undercooled melts. It was found that under local non-equilibrium conditions, the predicted results of the non-dilute solution model and the dilute solution model are to a certain extent different from each other at the intermediate undercooling range. It was also found that the concentration effect could substantially decrease the relaxation effect. Second, we considered the effect of fluid flow on the rapid solidification of an undercooled melt. It was found that the fluid flow would affect not only the size of the dendrite tip radius, mainly at the small undercooling range, but also the dendrite growth velocity at the intermediate undercooling range. In particular, fluid flow makes the sizes of the dendrite tip radius at high undercooling close to those predicted by the dilute model. Thus, fluid flow could make the non-dilute solution exhibit dilute solution solidification behaviors. It was also found that fluid flow reduces the relaxation effect to some extent. Considering the fluid flow effect, we used an extended chemical superheating model to predict the dendrite remelting phenomenon of the non-dilute melt. The model predicted that the dendrite remelting phenomenon would abruptly disappear once the dendrite growth velocity exceeded the solute diffusion velocity in a bulk undercooled melt. Third, considering the fluid flow effect, we used the concept of equivalent undercooling and a recently developed physical model to calculate the stress accumulation during rapid solidification. The results of this new model could explain well the stress-induced dendrite breakup mechanism of grain refinement at high undercooling.

Evolution of Dendrite Structure and Shrinkage Porosity in 30Cr15Mo1N Ingot with Pouring Rate

Carbon Macrosegregation Pattern in 30Cr15Mo1N Ingot: Impact of Pouring Rate

Investigation on Porosity Formation With Pressure Drop Between Dendrite Tip and Root During Pressurized Solidification of 30Cr15Mo1N Ingot

Simulating Study on the Shrinkage Cavity and Porosity of a Microalloyed Steel Ingot

Observation of Dendrite Growth Velocity and Microstructure Transition in Highly Undercooled Single Phase Alloys

Effect of the Cooling Rate on the Microstructure of Directionally Solidified Casting (CMSX-4 Ni Superalloy)

Concentration and Fluid Flow Effects on Kinetics, Dendrite Remelting and Stress Accumulation Upon Rapid Solidification of Deeply Undercooled Alloys

The Influence of Insertion Depth of Inorganic Materials on Solidification Microstructure and Segregation of 2.5-ton 42CrMo Ingot

Effect of Coupling Low-Flow Pouring with Inoculation on the As-Cast Microstructure of 7055 Alloys

Effect of Cooling Rate on the Grain Morphology and Element Segregation Behavior of Fe-Mn-Al-C Low-Density Steel During Solidification

Effects of cooling rates on microporosity in DC casting Al-Li alloy

Effect of Cooling Rates on the Local—Overall Morphology Characteristics of Solidification Structure at Different Stages for High Carbon Steel

Effect of the cooling rates on the microstructure and segregation characteristics in directionally solidified GH4151 superalloy

Experimental and Numerical Study of Macrosegregation in a 160 Steel Ingot

Microstructural Evolution with a Wide Range of Solidification Cooling Rates in a Ni-Based Superalloy

Four-Phase Dendritic Model for the Prediction of Macrosegregation, Shrinkage Cavity, and Porosity in A 55-Ton Ingot

Solidification behavior of undercooled Cu70Ni30 alloy melt

Internal Shrinkage Crack in a 10 T Water-Cooled Steel Ingot with a Large Height-to-diameter Ratio

Microstructure Evolution in Undercooled Ni-Si Melt

Delving Deep into the Influence of Pressure on Columnar‐to‐Equiaxed Transition in High‐Nitrogen Steel Ingot by Thermodynamics and Kinetics

Dendrite evolution and quantitative characterization of γ′ precipitates in a powder metallurgy Ni-based superalloy by different cooling rates