Abstract:Copper phthalocyanine (CuPc) doped zinc oxide (ZnO) interlayered Al/p-Si Schottky barrier diodes (SBDs) were systematically fabricated utilizing spin coating technique. This study was undertaken to meticulously assess the influence of varying concentrations of CuPc on the intricate electrical and photodiode characteristics of these devices. The investigation involved the characterization of the current–voltage ( I–V ) characteristics configured with distinct different doping concentrations of CuPc such as 0.05 wt%,1 wt%, 2 wt%, under a wide range of voltages (± 5 V) and illumination irradiances. These measurements enabled the calculation of various critical electrical variables, such as the ideality factor ( n ), barrier height (Φ B ), series resistance ( R s ), shunt resistance ( R sh ), interface states density ( N ss ) and their response under various illumination levels (between 10 and 100 mW/cm 2 ) and under dark condition. An increase in the reverse current as the illumination increases suggested the potential utility of these SBDs as photodiodes, photosensors, or photodetectors. Notably, the linear dynamic range (LDR), a crucial factor for image sensors which obtained around 14 for all photodiodes. The photodiodes exhibited a good rectification ratio (RR) of approximately 10 4 . The results obtained indicate that the rectifying properties of the structures can be controlled by CuPc doping. In addition, the results indicated that the presence of CuPc significantly influenced the values of n , Φ B , R s /R sh , and N ss . To further analyze the devices, capacitance–voltage ( C–V ) and conductance–voltage ( G–V ) measurements were carried out to determine parameters such as diffusion potential ( V D ), dopant acceptor atoms concentration ( N A ), Fermi energy level ( E F ), and width of depletion layer ( W D ) at both 1 kHz and 1 MHz. The measurements revealed that the capacitance values were higher at low frequencies compared to high frequencies, and this behavior was attributed to N ss . In summary, this study suggests that the manufactured photodiodes have the potential to be employed as photodiodes, sensors, or detectors in optical sensing applications, and their performance can be tailored by adjusting the concentration of CuPc in the ZnO interlayered structures. The discerned outcomes revealed the substantial influence of CuPc concentration on key electrical parameters, with conspicuous trends noted in the values of n , Φ B , R s /R sh , and N ss . Furthermore, the observed increase in the reverse current as the illumination level increases highlights the potential utility of these SBDs as sensitive photodiodes/sensors/detectors.

Fabrication of one‐dimensional Zn‐doped Bi2S3 nanorods for photodiode applications

Synthesis and Characterization of Bi2S3 Quantum Dot-Sensitized TiO2 Nanorod Arrays Coated with ZnSe Passivation Layers

Bismuth sulfoiodide (BiSI) nanorods: synthesis, characterization, and photodetector application

Fabrication of dye-sensitized solar cells with ZnO nanorods as photoanode and natural dye extract as sensitizer

Exploring the Impact of Ni Doping in Tuning the Bandgap, Electronic, Optoelectronic and Photocatalytic Properties of ZnFe2O4

Exploring and fine tuning the properties of one dimensional Bi2S3 nanorods

Enhancing DSSC Performance through Manipulation of the Size of ZnO Nanorods

Fabrication of P-Type Znse:Sb Nanowires for High-Performance Ultraviolet Light Photodetector Application

Investigations on structural, morphological and UV light detection characteristics in p- ZrO 2 / n-Si Heterostructure based devices

Na-Doped Zno Nanorods Fabricated by Chemical Vapor Deposition and Their Optoelectrical Properties

Fabrication of ZnO/ZnO @ carbon dot as photo anode and Natural dye as photosensitizer for dye sensitized solar cell application

Niobium Doped Zinc Oxide Nanorods As an Electron Transport Layer for High-Performance Inverted Polymer Solar Cells.

Scalable Colloidal Synthesis of Uniform Bi2S3nanorods As Sensitive Materials for Visible-Light Photodetectors

Structural and Optical Properties of Nickel-Doped Zinc Sulfide

Fabrication of enhanced performance Visible-light photodetector based on Ag/ZnS/p-Si/Ag heterojunction grown by chemical bath deposition

Photocatalytic activity of indium doped zinc oxide seed layers and one dimensional nanorods under solar irradiation

Fabrication and properties of sulfur (S)-doped ZnO nanorods

Synthesis of zinc oxide colloidal nanorods for inorganic–organic hybrid photodiode application

Vertical Hierarchical Architecture of Niobium Diselenide Nanosheets Loaded ZnO Nanorods for High‐Performance Self‐Powered Broadband Photodetection

Investigation of hybrid CuPc-doped ZnO/p-silicon photodiodes for photonic and electronic applications

Investigation of conduction mechanism and UV light response of vertically grown ZnO nanorods on an interdigitated electrode substrate