Changes in Corrosion Behaviour of Zinc and Aluminium Coatings with Increasing Seawater Acidification

Cezary Senderowski,Wojciech Rejmer,Nataliia Vigilianska,Arkadiusz Jeznach
DOI: https://doi.org/10.3390/ma17030536
IF: 3.4
2024-01-23
Materials
Abstract:The increase in greenhouse gas emissions has led to seawater acidification, increasing the corrosion rate of metal structures in marine applications. This paper indicates that the spraying of four types of coatings, namely Zn, Al, Zn-Al, and Al-Mg, using the arc-spraying technique on steel substrate S235JR, creates effective protective coatings that interact differently with various pH solutions exposed to varying levels of seawater acidification. The study analyses the structural properties of the coating materials using SEM and XRD techniques. Electrochemical parameters are evaluated in solutions with different pH and salinity levels. The results demonstrate that alloy metallic coatings provide excellent resistance to corrosion in low-pH solutions.
materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,metallurgy & metallurgical engineering
What problem does this paper attempt to address?
The paper primarily explores the changes in corrosion behavior of zinc (Zn) and aluminum (Al) coatings under conditions of intensified seawater acidification. As the increase in greenhouse gas emissions leads to a rise in seawater acidification, the corrosion rate of metal structures in marine environments also increases. To address this challenge, researchers used arc spraying technology to apply four different types of coatings on S235JR steel substrates: pure zinc (Zn), pure aluminum (Al), zinc-aluminum alloy (Zn-Al), and aluminum-magnesium alloy (Al-Mg). The study aims to evaluate the corrosion protection performance of these coatings under different pH values and salinity levels. The study used Scanning Electron Microscopy (SEM) and X-ray Diffraction (XRD) techniques to analyze the structural characteristics of the coating materials and evaluated the electrochemical parameters of the coatings in solutions with different pH values and salinity through electrochemical tests. The results showed that alloy metal coatings exhibited excellent corrosion resistance in low pH solutions. Specifically: 1. **Coating Preparation and Characteristics**: The study used arc spraying technology to prepare four types of coatings and analyzed their microstructure and chemical composition. The coating thickness ranged from approximately 250 μm to 710 μm, and the surface roughness was between 9.73 μm and 12.59 μm. Aluminum coatings were thicker than zinc coatings, possibly due to the lower vapor pressure of aluminum. 2. **Corrosion Performance Evaluation**: The corrosion behavior of the coatings in solutions with different pH values and salinity levels was evaluated using electrochemical Linear Polarization Resistance (LPR) tests. The results indicated that with the intensification of seawater acidification, the corrosion current density and corrosion rate of zinc coatings increased; whereas aluminum and its alloy coatings exhibited better corrosion resistance, especially in low pH environments. 3. **Impact of Environmental Factors**: The experimental design considered the predicted changes in seawater pH over the next few decades (from 8 to 7) and the effects of different salinity levels (seawater 30 g/L, river water 7 g/L). The study found that lowering the pH value and increasing the salinity would both increase the corrosion current density, thereby accelerating the corrosion process. In summary, this study aims to experimentally verify the corrosion protection capabilities of different metal coatings under simulated future seawater acidification conditions, providing scientific evidence for selecting protective coatings suitable for future marine environments.