Yield and distribution of products of lignin liquefaction catalyzed by molybdenum-vanadium-phosphorus heteropolyacids

Min Chen,Jing Lou,Yang Zhang,Lu Li,Yan Li,Xin-an Xie
DOI: https://doi.org/10.1080/15567036.2024.2322016
2024-03-19
Energy Sources Part A Recovery Utilization and Environmental Effects
Abstract:This paper focuses on the performance of Molybdenum-vanadium-phosphorus heteropolyacids (PMo 12-x V x ) with different V-doped amounts in catalyzing the conversion of lignin to bio-oil, and the distribution of liquefied products. Molybdenum-vanadium-phosphorus heteropolyacids (PMo 11 V 1 , PMo 10 V 2 , PMo 9 V 3 ) with different amount (0, 2.5, 5, 10 w t %) were used to catalyze lignin liquefaction. The experimental results showed that PMo 12-x V x could effectively catalyze the depolymerization of lignin to bio-oil, and the doping amount of the V atom in PMo 12-x V x affects the distribution of lignin depolymerization products. The highest bio-oil yield (53.62w t %) and conversion (57.83w t %) could be obtained from lignin liquefaction at 2.5 w t % PMo 9 V 3 . With the increase of PMo 12-x V x V-atom doped amount, the content of aliphatic hydrocarbons increased from 3.14% to 40.58%, the content of vanillin increased from none to 8.9%. Based on the analysis of bio-oil, FT-IR data, and DFT simulation results, it was found that the selective cleavage of the C α -C β bond and the ring-opening of the carbon at the methyl end of lignin were the main reasons for the high yield of vanillin and aliphatic hydrocarbons during the depolymerization of lignin catalyzed by PMo 12-x V x . Finally, a possible reaction pathway for the PMo 12-x V x -catalyzed depolymerization of lignin to vanillin and aliphatic hydrocarbons was proposed.
energy & fuels,engineering, chemical
What problem does this paper attempt to address?