Abstract:Magnetic fluid seals are widely used. However, during the filling process of the magnetic fluid, a large part of the magnetic fluid is attracted to the magnet, causing the loss of the magnetic fluid, and the magnetic fluid sealing device can easily cause damage to the pole teeth due to the problem of disassembly and installation. To solve the above problems, this article designs a pole piece integrated magnetic-fluid sealing structure and a new type of disassembly and installation method. The finite element method is used to calculate the magnetic field distribution of the pole piece integrated magnetic fluid seal structure, and the theoretical withstand pressure value is obtained according to the withstand pressure calculation formula. Three kinds of magnetic fluids were used to conduct comparative experiments on the magnetic fluid sealing device at different temperatures and different filling amounts. The results showed that the pressure resistance of the magnetic fluid sealing increased with the increase of the filling amount, and the increase of the saturation magnetization, consistent with theory. It is also found that the thickness of the pole piece is very thin. During the processing, Compared with the ordinary pole piece, the integrated pole piece has the advantage of large length, the coaxial is easily ensured, and the processing difficulty is reduced; second, during the filling process, all the magnetic fluid is sucked to the pole teeth, there is no loss of the magnetic fluid, and the pole teeth are intact after more than a hundred times of disassembly and installation, which further improves the life of the magnetic fluid sealing device.

Sealing mechanism investigation of convergent ferrofluid seals with staggered pole teeth

Experimental Study on the Critical Pressure of Converging Ferrofluid Seal with Alternating Pole Teeth

Failure mechanism and pressure resistance investigation of divergent magnetic fluid seals with staggered pole teeth

Numerical and experimental investigation of a large gap convergent ferrofluid seal with the stepped pole piece

Numerical and experimental study on pole teeth interlaced divergent ferrofluid seals with single magnetic source

Experimental Study of Converging Ferrofluid Seal with Small Clearance and Double Magnetic Sources

Preparation of Diester-Based Ferrofluid and Applied Research in Sealing

Numerical and Experimental Studies of a Novel Converging Stepped Ferrofluid Seal

The Wear of Seal Fins During High-Speed Rub Between Labyrinth Seal Fins and Honeycomb Stators at Different Incursion Rates.

Experimental study of sealing mechanism and sealing performance of symmetric magnetic fluid seal with occlusal pole teeth

Experiment and Simulation on the Ferrofluid Boundary Deformation and Fluctuation Characters of a High-Speed Rotary Seal

Design of Magnetic Circuit and Finite Element Analysis of Stepped Ferrofluid Seal with Small Sealing Gap

Experimental investigation on the critical pressure and self-repairing capability of converging magnetic fluid seal with stepped pole pieces

Experimental Validation and Numerical Simulation of Static Pressure in Multi-Stage Ferrofluid Seals

Experimental Study and Simulation on the Seal Pressure of a Ferrofluid Seal Using Radial-Charged Magnets

Sealing Behavior Research on the Radial Ferrofluid Seal Structure with Oblique Teeth

Experimental study on self-repairing performance of the interlaced ferrofluid seal

Numerical Analysis and Experimental Study on Pole Piece Integrated Magnetic Fluid Seal

Pressure Capability Analysis of Magnetic Powder Seals and Pole Tooth Design by Multiparameter Optimization

Numerical and experimental study of divergent magnetic fluid seals with stepped pole pieces

Influence of temperature on the sealing mechanism and sealing performance for magnetic fluid seal with opposite pole teeth in different environments