Abstract:Magnetic fluid seals are widely used. However, during the filling process of the magnetic fluid, a large part of the magnetic fluid is attracted to the magnet, causing the loss of the magnetic fluid, and the magnetic fluid sealing device can easily cause damage to the pole teeth due to the problem of disassembly and installation. To solve the above problems, this article designs a pole piece integrated magnetic-fluid sealing structure and a new type of disassembly and installation method. The finite element method is used to calculate the magnetic field distribution of the pole piece integrated magnetic fluid seal structure, and the theoretical withstand pressure value is obtained according to the withstand pressure calculation formula. Three kinds of magnetic fluids were used to conduct comparative experiments on the magnetic fluid sealing device at different temperatures and different filling amounts. The results showed that the pressure resistance of the magnetic fluid sealing increased with the increase of the filling amount, and the increase of the saturation magnetization, consistent with theory. It is also found that the thickness of the pole piece is very thin. During the processing, Compared with the ordinary pole piece, the integrated pole piece has the advantage of large length, the coaxial is easily ensured, and the processing difficulty is reduced; second, during the filling process, all the magnetic fluid is sucked to the pole teeth, there is no loss of the magnetic fluid, and the pole teeth are intact after more than a hundred times of disassembly and installation, which further improves the life of the magnetic fluid sealing device.

Experimental Study and Simulation on the Seal Pressure of a Ferrofluid Seal Using Radial-Charged Magnets

Experimental Validation and Numerical Simulation of Static Pressure in Multi-Stage Ferrofluid Seals

Experimental Study on the Critical Pressure of Converging Ferrofluid Seal with Alternating Pole Teeth

Numerical and experimental study on pole teeth interlaced divergent ferrofluid seals with single magnetic source

Sealing Behavior Research on the Radial Ferrofluid Seal Structure with Oblique Teeth

Analysis on Seal Capacity of Magnetic Fluid Seal Using Ring Magnet

Numerical Simulation and Experimental Study on Magnetorheological Fluid Seals with Flexible Pole Pieces

Magnetic field simulation and experimental investigation of magnetic fluid seal based on rotating shaft

Numerical Analysis and Experimental Study on Pole Piece Integrated Magnetic Fluid Seal

Experimental Study of Converging Ferrofluid Seal with Small Clearance and Double Magnetic Sources

Studies of Magnetic Fluid Plane Sealing in Split Sealing Device

Numerical and Experimental Study of Magnetic Fluid Seal with Large Sealing Gap and Multiple Magnetic Sources

Numerical and Experimental Studies of a Novel Converging Stepped Ferrofluid Seal

Design of Magnetic Circuit and Finite Element Analysis of Stepped Ferrofluid Seal with Small Sealing Gap

Numerical and experimental investigation of a large gap convergent ferrofluid seal with the stepped pole piece

Theoretical Analysis and Experimental Study on Loading Process among Stages of Magnetic Fluid Seal

Theoretical Analysis and Experimental Study on the Influence of Magnet Structure on Sealing Capacity of Magnetic Fluid Seal

Experiment and Simulation on the Ferrofluid Boundary Deformation and Fluctuation Characters of a High-Speed Rotary Seal

A comparative study of magnetic seals by ferrofluids, magnetorheological fluids and magnetic powders

Pressure Capability Analysis of Magnetic Powder Seals and Pole Tooth Design by Multiparameter Optimization

Preparation of Diester-Based Ferrofluid and Applied Research in Sealing