Abstract:Lithium-rich layered oxides have attracted much attention due to their high discharge capacity (>250 mA h·g–1). However, lithium-rich layered cathodes suffer from poor rate capabilities and voltage decay, which seriously limit their practical application. Herein, a unique @spinel double-spinel shell heterostructure is designed and successfully synthesized via coprecipitation and high-temperature solid-phase methods. In particular, lithium-rich layered oxides show good rate capabilities and high capacity retention when the molar amount of cobalt acetate and manganese acetate is 5%. After 100 cycles at 0.2 C, a discharge capacity of 232 mA h g–1 and a capacity retention of 92.7% can be obtained. The superior electrochemical performance of the in situ-transformed Li-rich layered cathode can be attributed to the unique three-dimensional diffusion channels for Li ions of the surface spinel phase. Besides, the in situ-transformed LiCoMnO4 shell can also improve the structural stability of the Li-rich layered oxides by reducing the side reactions and protecting the material from being corroded by the electrolyte. This study provides a strategy for surface modification, which can effectively improve the electrochemical performance of Li-rich layered cathode materials with high performance.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsaem.1c01955.SEM image of the precursor Ni1/6Co1/6Mn4/6CO3 and the corresponding mapping spectrum; ex situ XRD spectra of the LLO and LSS-0.05 samples; EDS line scan of the selected area and the corresponding HTEM diagram of the LSS-0.05 sample; CV and dQ/dV curves of the first three cycles of the LLO, LSS-0.05, and LSS-0.1 samples; initial charge and discharge curves of LiCoMnO4, LSS-0.2, and LSS-0.4 samples; discharge curves of LLO, LSS-0.05, and LSS-0.1 samples at different rates and with different cycles; typical single titration curve of GITT measurements; equivalent circuit of half-cells; and EIS spectra of LLO, LSS-0.05, and LSS-0.1 samples in the initial cycle (PDF)This article has not yet been cited by other publications.

Understanding the key role of {100} exposed crystal facets on the electrochemistry of the spinel LiMn2O4 cathode

General Synthesis of Single‐Crystal Spinel Cathodes with the Tailored Orientation of Exposed Crystal Planes for Advanced Lithium‐Ion Batteries

Crystalline geometry engineering towards high-energy spinel cathode for lithium-ion batteries

Atomic insights into surface orientations and oxygen vacancies in the LiMn2O4 cathode for lithium storage

From Hydrated Layered-Spinel Lithium Manganate Composite to High-Performance Spinel Limn2o4: A Novel Synthesis Tuned by the Concentration of Lioh

Engineering d-p orbital hybridization for high-stable lithium manganate cathode

Enhanced long-term cyclability in Li-Rich layered oxides by electrochemically constructing a LixTM3-xO4-type spinel shell

Boosting the Electrochemical Performance of a Spinel Cathode with the In Situ Transformed Allogenic Li-Rich Layered Phase

Overlithiation-driven structural regulation of lithium nickel manganese oxide for high-performance battery cathode

Improving the Electrochemical Performance of a Lithium-Rich Layered Cathode with an In Situ Transformed Layered@Spinel@Spinel Heterostructure

Topotactic Phase Transformation of Lithiated Spinel to Layered LiMn0.5Ni0.5O2: The Interaction of 3-D and 2-D Li-ion Diffusion

Engineering Manganese-rich Phospho-olivine Cathode Materials with Exposed Crystal (010) Facets for Practical Li-ion Batteries

Unusual Spinel-to-Layered Transformation in LiMn 2 O 4 Cathode Explained by Electrochemical and Thermal Stability Investigation.

Crystallographic‐Site‐Specific Structural Engineering Enables Extraordinary Electrochemical Performance of High‐Voltage LiNi 0.5 Mn 1.5 O 4 Spinel Cathodes for Lithium‐Ion Batteries

Optimized Morphology and Tuning the Mn3+ Content of LiNi0.5Mn1.5O4 Cathode Material for Li-Ion Batteries

Stabilizing Crystal Framework of an Overlithiated Li1+ xMn2O4 Cathode by Heterointerfacial Epitaxial Strain for High-Performance Microbatteries

Optimal Facet Assembly of Multi-Transition Metals Layered Cathodes toward Superior Li-Ion Kinetics and Structural Stability

Implication of Lithium Excess Induced Structure and Electrochemical Behavior Changes of LiNi 0.5 Mn 1.5 O 4 Spinel

Electrochemical Behavior And Surface Structural Change Of Limn2o4 Charged To 5.1 V

Lithium Manganese Spinel Cathodes for Lithium‐Ion Batteries

The High Proportion of (110) Specific Crystal Face in Single Crystal LiNi0.5Co0.2Mn0.3O2 Improving the Rate Performance and Testing the Application in Pouch Batteries