Abstract:The study presented in the article focuses on modelling of thin-walled cylindrical shell structures with initial geometrical imperfections under external radial pressure. The critical pressure of the perfect shell obtained using linear analysis significantly exceeded that calculated by the Papkovich formula. This discrepancy can be attributed to the shell displacement constraints and the fact that linear analysis provides non-conservative estimates. Initially, the geometric imperfections were assumed to follow an eigenmode-affine pattern with varying amplitudes. Critical pressure values iteratively determined using the modified Ricks method were found to be lower than the critical pressure of the first buckling mode. Importantly, all these values remained notably higher than the normative value. Subsequently, the initial imperfections were modelled as combinations of sinusoidal deviations with different amplitudes and varying numbers of waves along the perimeter. Short-wavelength eigenmode-affine imperfections were superimposed on longer-wavelength deviations. The research indicated that while the long-wavelength imperfections had a marginal impact on the critical pressure values, they notably altered the post-buckling behaviour of the shell, as depicted in load-deflection figures in the form of loops. These processes occurred at pressure levels considerably higher than the normative value. The simulation results are in good agreement with established theories regarding the pre- and post-buckling behaviour of thin-walled shells. Nonlinear analysis revealed that the actual critical pressure values exceeded the normative value by 30-45%, and the post-buckling pressure values exhibited a gradual decrease without posing a threat to abrupt changes in the geometry of the shells. This outcome provides a basis for a more accurate estimation of the load-carrying capacity of the shell structures.

The Axial Compressive Response of Thin, Elastic, Polygonal Shells

Buckling Strength of Tapered Cylindrical Shells under Partial Axial Compression: Effect of Circumferential Weld-Induced Imperfections

Advances in Buckling Analysis of Axial Compression Loaded Thin-walled Cylindrical Shells Based on Initial Imperfection Sensitivity

Buckling Behavior Analysis of Thin-Walled Cylindrical Shell Structure under Localized Axial Compression Load Based on Initial Imperfection Sensitivity

Buckling of the Axially Compressed Cylindrical Shells with Arbitrary Axisymmetric Thickness Variation

Analytical Study on the Buckling of Cylindrical Shells with Arbitrary Thickness Imperfections under Axial Compression

Form of Circumferential Weld-Induced Imperfections for Tapered-Wall Cylindrical Shell Structures

Buckling Test of Metallic Thin-Walled Cylindrical Shells under Non-Uniform Axial Compression Loads

A New Design Method For Axially Loaded Thin-Walled Cylindrical Shells Based On Elasto-Plastic Buckling Analysis

Study on the Axial Compression Buckling Behaviors of Concentric Multi-Walled Cylindrical Shells Filled with Soft Materials

Buckling of cylindrical shells with general axisymmetric thickness imperfections under external pressure

Numerical Study on Buckling Behaviors of Thin-Walled Longitudinal Corrugated Cylindrical Shells under Axial Compression Loads

Localized Perturbation Load Approach for Buckling Design of Thin-Walled Steel Cylindrical Shells under Partial Axial Compression

Buckling analyses of thin-walled cylindrical shells subjected to multi-region localized axial compression: Experimental and numerical study

Buckling Analysis of Variable Stiffness Composite Cylindrical Shells Under Axial Compression Considering Imperfection Sensitivity

Analytical Research on Dynamic Buckling of Thin Cylindrical Shells with Thickness Variation under Axial Pressure

Buckling behaviors of thin-walled cylindrical shells under localized axial compression loads, Part 1: Experimental study

Buckling behaviors of thin-walled cylindrical shells under localized axial compression loads, Part 2: Numerical study

Buckling of thin-walled cylindrical shell structures with axially variable elastic modulus under axial compression

Buckling of composite cylindrical shells with ovality and thickness variation subjected to hydrostatic pressure

Computer modelling of thin-walled shell structures with geometric imperfections