Abstract:A multi-modulus architecture based on the radix-8 Booth encoding of a modulo (2n − 1) multiplier, a modulo (2n) multiplier, and a modulo (2n + 1) multiplier is proposed in this paper. It uses the original single circuit and shares many common circuit characteristics with a small extra circuit to carry out multi-modulus operations. Compared with a previous radix-4 study, the radix-8 architecture can increase the modulation multiplication encoding selection from three codes to four codes. This reduces the use of partial products from ⌊n/2⌋ to ⌊n/3⌋ + 1, but it increases the operation complexity for multiplication by three circuits. A hard multiple generator (HMG) is used to address this problem. Two judgment signals in the multi-modulus circuit can be used to perform three operations of the modulo (2n − 1) multiplier, modulo (2n) multiplier, and modulo (2n + 1) multiplier at the same time. The weighted representation is used to reduce the number of partial products. Compared with previously reported methods in the literature, the proposed approach can achieve better performance by being more area-efficient, being faster, consuming low power, and having a lower area-delay product (ADP) and power-delay product (PDP). With the multi-modulus HMG, the proposed modified architecture can save 34.48–55.23% of hardware area. Compared with previous studies on the multi-modulus multiplier, the proposed architecture can save 22.78–35.46%, 4.12–11.15%, 12.59–24.73%, 27.88–38.88%, and 20.49–27.85% of hardware area, delay time, dissipation power, ADP, and PDP, respectively. Xilinx field programmable gate array (FPGA) Vivado 2019.2 tools and the Verilog hardware description language are used for synthesis and implementation. The Xilinx Artix-7 XC7A35T-CSG324-1 chipset is adopted to evaluate the performance.

Efficient modular hybrid adders and Radix-4 booth multipliers for DSP applications

High Quality Multiplier Design Based on Improved Circuits

Implementation and Comparison of Radix-8 Booth Multiplier by using 32-bit Parallel prefix adders for High Speed Arithmetic Applications

Design of low-power and high-speed multiplier

A modular technique of Booth encoding and Vedic multiplier for low-area and high-speed applications

High Speed Low Power Radix 4 Approximate Booth Multiplier

Design and Implementation of Area Efficient Low Latency Radix-8 Multiplier on FPGA

Asic Implementation of 12-Bit Radix-8 Booth Multiplier

Booth Multiplier Design Using Modified Square Root Carry-Select-Adder

A Combined Arithmetic-High-Level Synthesis Solution to Deploy Partial Carry-Save Radix-8 Booth Multipliers in Datapaths

Design of Delay Efficient Hybrid Adder for High Speed Applications

Multiplier Design Addressing Area-Delay Trade-offs by using DSP and Logic resources on FPGAs

Design of an Accurate, Cost-effective Radix-4 Booth Multiplier

High-Speed Energy-Efficient Fixed-Point Signed Multipliers for FPGA-Based DSP Applications

Approximate Radix-8 Booth Multipliers for Low-Power and High-Performance Operation

Area, Delay, and Energy-Efficient Full Dadda Multiplier

A Design and Implementation of Radix-4 Based Fast Multiplier on FPGA

Low Power Shift and Add Multiplier Design

Area-Power-Delay-Efficient Multi-Modulus Multiplier Based on Area-Saving Hard Multiple Generator Using Radix-8 Booth-Encoding Scheme on Field Programmable Gate Array

Design and Implementation of Radix 8 Booth Encoding Multiplier for Low Area and High-Speed Applications

Design of efficient binary multiplier architecture using hybrid compressor with FPGA implementation