Abstract:Frequency selective surface (FSS) has extensively been investigated over the past decades. The most famous applications of FSS are used for antennas radome and controlling radar cross section (RCS). FSS radome could reflect the signal out of the band so that the RCS could be reduced by shaping. However, with the development of radar detection technology, the scattering out of the band becomes non-negligible. In order to improve the problem, the FSS rasorber was proposed. It is the combination of the absorber and the radome. In this paper, a wideband transmission FSS rasorber is designed, acting as a stealthy radome to reduce the scattering out of band of the antenna system. The rasorber consists of an absorption layer (LayerA) and a transmission layer (LayerT). The LayerA, which use a resistor-loaded in Jerusalem cross element with non-touching centre, provides stable losses out of band and minimizes losses in the band. The LayerT use as the ground plane of an absorber based on the absorption layer within the total reflection band and providing a transmission window in the band. In order to obtain a wideband transmission, two series chokes are inserted in each leg in the LayerA and the LayerT adopts a second-order resonator. Moreover, the elements are packed densely owing to a skewed grid in the LayerA and the miniaturized non-resonant element in the LayerT. Superdense arrays cause a more stable performance of the rasorber, especially the delay of grating lobes onset. The composite structure is thoroughly analyzed by means of the full-wave numerical simulation. The simulation shows that the -1 dB transmission window is 5.7 ~ 6.7 GHz, and the -10dB reflection band is 2.2 ~ 5.1 GHz. The design would be widely used in broadband antenna system.

Wideband low-RCS and gain-enhanced antenna using frequency selective absorber based on patterned graphene

Design of a Wideband Absorption Frequency Selective Rasorber Based on Double Lossy Layers

Enhanced High-gain Antenna Design with Phase-Controlled Frequency Selective Rasorber for LowRCS Performance

Low-RCS Holographic Antenna with Enhanced Gain Based on Frequency-Selective Absorber

A Wideband Transmission Frequency Selective Surface Rasorber

An Integrated Antenna Array With Broadband, Low-RCS, and High-Gain Characteristics

Wideband Low RCS Antenna Based on Hybrid Absorptive-Diffusive Frequency Selective Reflector

A Low-RCS and High-Gain Fabry-Pérot Antenna Based on Hybrid Absorptive-Diffusive Metasurface

A High-Gain Wideband Fabry-Pérot Antenna Employing a Water-Based Frequency Selective Surface for Polarization- and RCS-Reconfigurability

Broad bandwidth of thin composite radar absorbing structures embedded with frequency selective surfaces

A Wideband Transmission Frequency Selective Surface Rasorber with Low Insertion Loss

A Low-RCS and Wideband Circularly Polarized Array Antenna Co-Designed With a High-Performance AMC-FSS Radome

Ultra-wideband RCS reduction and gain enhancement of patterned-surface-based aperture coupling patch antenna with optimized arrangement method

Novel Low-RCS Circularly Polarized Antenna Arrays via Frequency-Selective Absorber

Out-of-band RCS Reduction of a Dipole Antenna Based on Frequency-Selective Metasurface

Broadband Flexible Metasurface-Inspired Antenna Array with Lower Scattering on Curved Surfaces

An Absorptive/ Transmissive Frequency Selective Surface Based Low-RCS Microstrip Antenna Array

Broadband low-scattering and high-efficiency transmission radome by combining phase gradient metasurface and FSS

Low-profile shared-aperture metasurface array antenna with ultra-wideband radar cross section reduction and circularly polarization

RCS reduction of wide-band, high-gain antenna array based on asymmetric transmission metasurfaces

Tapered Resistive Sheets and FSS Absorber Loading for the Wideband RCS Reduction of the Elliptic Surface at TM Polarization