Abstract:Visible light communication (VLC) is one of the key technologies for the sixth generation (6G) to support the connection and throughput of the Industrial Internet of Things (IIoT). Furthermore, VLC channel modeling is the foundation for designing efficient and robust VLC systems. In this paper, the ray-tracing simulation method is adopted to investigate the VLC channel in IIoT scenarios. The main contributions of this paper are divided into three aspects. Firstly, based on the simulated data, large-scale fading and multipath-related characteristics, including the channel impulse response (CIR), optical path loss (OPL), delay spread (DS), and angular spread (AS), are analyzed and modeled through the distance-dependent and statistical distribution models. The modeling results indicate that the channel characteristics under the single transmitter (TX) are proportional to the propagation distance. It is also found that the degree of time domain and spatial domain dispersion is higher than that in the typical rooms (conference room and corridor). Secondly, the density of surrounding objects and the effects of user heights on these channel characteristics are also investigated. Through the analysis, it can be observed that the denser objects can contribute to the smaller OPL and the larger RMS DS under the single TX case. Furthermore, due to the blocking effect of surrounding objects, the larger OPL and the smaller RMS DS can be observed at the receiver with a low height. Thirdly, due to the distance dependence of the channel characteristics and large time-domain dispersion, the link adaption method is further proposed to optimize the multipath interference problem. This method combines a luminary adaptive selection and delay adaption technique. Then, the performance of the link adaption method is verified from four aspects through simulation, including the signal-to-noise (SNR), the RMS DS, the CIRs, and the bit-error rate (BER) of a direct-current-biased optical orthogonal frequency division multiplexing (DCO-OFDM) system. The verification results indicate that our proposed method has a significant optimization for multipath interference.

Ultra-Reliable Communications for Industrial Internet of Things: Design Considerations and Channel Modeling

3GPP Standardized 5G Channel Model for IIoT Scenarios: A Survey

URLLC Based Cooperative Industrial IoT Networks with Non-Linear Energy Harvesting

5G Control Channel Design for Ultra-Reliable Low-Latency Communications

Traffic Scheduling for 5G-TSN Integrated Systems

Vision-aided Ultra-Reliable Low-Latency Communications for Smart Factory

Research on Ultra-Reliable and Low-Latency Wireless Communications in Smart Factory with Finite Block-Length.

A Low-latency and Interoperable Industrial Internet of Things Architecture for Manufacturing Systems.

Channel Characteristics and Link Adaption for Visible Light Communication in an Industrial Scenario

Quasi-Deterministic Modeling for Industrial IoT Channels Based on Millimeter Wave Measurements

A General 3D Geometry-Based Stochastic Channel Model for B5G mmWave IIoT

5G Ultra-Reliable Low-Latency Communication Implementation Challenges and Operational Issues with IoT Devices

Intelligent Reflecting Surface-aided URLLC in a Factory Automation Scenario

Smart Channel Sounder for 5G IoT: from Wireless Big Data to Active Communication

Tuning of Ray-Based Channel Model for 5G Indoor Industrial Scenarios

Analysis of 3GPP and Ray-Tracing Based Channel Model for 5G Industrial Network Planning

An Interoperable and Flat Industrial Internet of Things Architecture for Low Latency Data Collection in Manufacturing Systems

Non-Stationary Channel Modeling for Wireless Communications Underlaying UAV-Based Relay-Assisted IIoT Networks in the Sub-Terahertz Band

Beyond 5G URLLC evolution: New service modes and practical considerations

Resource Management for Millimeter-Wave Ultra-Reliable and Low-Latency Communications

AI for industrial: automate the network design for 5G URLLC services