Abstract:Wake vortex evolution of a square cylinder with a slot synthetic jet issuing from the cylinder’s rear surface has been experimentally investigated using the time-resolved particle image velocimetry technique. The Reynolds number based on the side length of the square cylinder is $Re=836$. The excitation frequency normalized by the natural shedding frequency $f_{e}/f_{0}$ varies from 0 to 6 at the dimensionless stroke length $L_{0}/w=72.6$. The distributions of the time-averaged Reynolds stresses present significant differences as the excitation frequency increases. With control, the mean streamwise velocity deficit of the wake recovers more quickly in comparison with the natural case, and the vertical velocity fluctuation intensity becomes weaker. Moreover, a drag reduction can be achieved for the control cases, especially, for $f_{e}/f_{0}=4$ and $f_{e}/f_{0}=6$, a thrust instead of drag reduction can be obtained. The profiles of the mean streamwise velocity tend to have jet-like distributions. The wake vortex dynamics and its evolution with the excitation frequency are revealed. (i) For the low excitation frequency cases ($f_{e}/f_{0}=0.5$, 1, 2), no significant changes in the dominant frequency and the spanwise vortex structures are observed in comparison with the natural case. (ii) For the moderate excitation frequency case ($f_{e}/f_{0}=3$), the wake vortex shedding frequency is locked on half of the control frequency. In this case, the shear layer is divided into two parts by the synthetic jet vortex, and the wake vortices with smaller scales still shed asymmetrically and appear closer to the square cylinder. (iii) For the high excitation frequency case ($f_{e}/f_{0}=6$), the flow is governed by the synthetic jet. As a result of strong perturbations of the synthetic jet, the wake vortex shedding becomes symmetric with the shedding frequency consistent with the control frequency. And the separation is suppressed effectively. The different control effects of the slot synthetic jet on a square cylinder and a circular cylinder are also compared in detail. Generally speaking, the circular cylinder is easier to be controlled due to its non-fixed separation points.

Improvement of vortex shedding control and drag reduction on a square cylinder using twin plates

Wake Vortex Evolution of Square Cylinder with A Slot Synthetic Jet Positioned at the Rear Surface

Vortex Separation and Interaction in the Wake of Inclined Trapezoidal Plates

Flow control around two side-by-side square cylinders using dual splitter plates

A computational study of drag reduction and vortex shedding suppression of flow past a square cylinder in presence of small control cylinders

Wake control of a square cylinder: Impinging the vortex cores with dual flexible splitter plates

Enhancing hydrodynamic drag and lift reduction around two staggered obstacles via control plates

System Identification and Model Predictive Control of Vortex Shedding Behind a Rotating Cylinder

Control of Vortex Shedding from Two Side-by-side Cylinders Using a Pair of Tangential Jets

Control of vortex shedding from a plate at incidence angles in the range of 0-90 deg

Influence of an upstream attached flat plate on the Newtonian flow past a square cylinder

Simulations of passive oscillation of a flexible plate in the wake of a cylinder by immersed boundary method

Dynamics of Two-Dimensional Flow Around a Circular Cylinder with Flexible Filaments Attached

An experimental investigation of the flow control of a circular cylinder in near wake with parallel plates at Re = 7500

A drag and lift passive control study of Carreau–Yasuda fluid in a channel with a cylinder rooted in a transient flow

Experimental study on the wake control of a square cylinder mounted with dual rigid/flexible splitter plates in the subcritical regime

Experimental investigation of distributed cross-plates effects on suppressing vortex-induced vibration of a flexible cylinder

Control of circular cylinder flow via bilateral splitter plates

The wake characteristics and hydrodynamic forces of a near-wall circular cylinder with the splitter plate

Experimental investigation on the optimal control of vortex shedding of a circular cylinder with rotating rods at moderate Reynolds numbers

Impact of a Cold Control Plate on Fluid Flow and Heat Transfer across an Isothermally Heated Rotary Oscillating Circular Cylinder