Abstract:The laser power and scan speed are significant processing parameters influencing the defects and microstructures due to affecting the thermal state within the melt pool during laser powder bed fusion (LPBF). To this end, these process parameter combinations under a constant laser energy density are correlated with defects (balling phenomenon and pores) and microstructures (melt pool arrangement and cell morphology). Setting the parameter combination (laser power and scan speed are 200 W and 910 mm/s, respectively) yields large balling droplets (average size of 150 μm) due to the relatively high melt viscosity resulting from the low melt pool temperature. In this case, a limited surface tension difference acting on a liquid surface cannot provide sufficient driving forces against viscous drags to promote the efficient spreading of the molten alloy. Cavity regions are formed between the large balling droplets and the previous layer, forming lack-of -fusion pores. By increasing the laser power and scan speed gradually, samples with relative densities greater than 99.5% are produced. This phenomenon can be attributed to the increases in laser power and scan speed, which improves the spreading ability of the molten alloy. With increasing laser power and scan speed, the cell size decreases (from 0.51 μm to 0.42 μm) because of the increase in the cooling rate. The sample (laser power and scan speed are 350 W and 1590 mm/s, respectively) has the highest performance (310 MPa yield strength, 470 MPa ultimate tensile strength, and 6.6% fracture strain) due to its highest relative density (greater than 99.5%) and fine microstructure (average cell size of 0.45 μm). All four samples exhibit anisotropic mechanical properties resulting from the combination of the melt pool boundary and lack-of-fusion pores.

The effect mechanism of laser beam defocusing on the surface quality of IN718 alloy prepared by laser powder bed fusion

Effect of Defocusing Distance on Laser Powder Bed Fusion of High Strength Al-Cu-Mg-Mn Alloy

Experimental and numerical exploration of defocusing in Laser Powder Bed Fusion (LPBF) as an effective processing parameter

The Influence of Laser and Powder Defocusing Characteristics on the Surface Quality in Laser Direct Metal Deposition

Formation mechanisms of lack of fusion and keyhole-induced pore defects in laser powder bed fusion process: A numerical study

Numerical Investigation of the Mechanism of Interfacial Dynamics of the Melt Pool and Defects During Laser Powder Bed Fusion

Effect of dual-laser powder bed fusion on surface quality, internal defects and properties of 316L stainless steel

Formation mechanism of pore defects and surface ripples under different process parameters via laser powder bed fusion by numerical simulation and experimental verification

Dual-beam Laser-Matter Interaction at Overlap Region During Multi-Laser Powder Bed Fusion Manufacturing

Effect of Surface Modification on the High Temperature Low Cycle Fatigue Performance of LPBF 316L Austenitic Steel

Influence of powder size on defect generation in laser powder bed fusion of AlSi10Mg alloy

Numerical simulation and experimental study on forming of overhang structure by laser power bed fusion of In718 alloy

Pore defects in Laser Powder Bed Fusion: Formation mechanism, control method, and perspectives

Formation mechanisms and control strategies of metallurgical defects and microstructures during laser powder bed fusion of AlSi10Mg lattice structures

Investigation of Laser-Powder Interaction in Laser Powder Bed Fusion Process in Additive Manufacturing

Research Progress on Spatter Behavior in Laser Powder Bed Fusion

Layer-wise Surface Quality Improvement in Laser Powder Bed Fusion Through Surface Anomaly Detection and Control

Particle-scale computational fluid dynamics study on surface morphology of GH4169 superalloy during multi-laser powder bed fusion with low energy density

High power laser powder bed fusion of Inconel 718 alloy: Effect of laser focus shift on formability, microstructure and mechanical properties

Processing defect, microstructure evolution and mechanical properties of laser powder bed fusion Al-12Si alloys

Promoting the densification and grain refinement with assistance of static magnetic field in laser powder bed fusion