Abstract:Bolts have the advantages of simple installation and easy removal. They are widely applied in aerospace and high-speed railway traffic. However, the loosening of bolts under mixed loads can lead to nonlinear decreases in pre-loading. This affects the safety performance of the structure and may lead to catastrophic consequences. Existing techniques cannot be used to monitor the bolt performance status in time. This has caused significant problems with the safety and reliability of equipment. In order to study the relaxation law of bolt pre-loading, this paper carries out an experimental analysis for 8.8-grade hexagonal bolts and calibrates the torque coefficient. We also studied different loading waveforms, nickel steel plate surface roughnesses, tangential displacement frequencies, four different strengths and bolt head contact areas of the bolt, the initial pre-loading, and the effects of tangential cyclic displacement on pre-loading relaxation. This was done in order to accurately predict the degree of bolt pre-loading loosening under external loads. The laws are described using the allometric model function and the nine-stage polynomial function. The least squares method is used to identify the parameters in the function. The results show that bolts with a smooth surface of the connected structure nickel steel flat plate, high-frequency working conditions, half-sine wave, and a high-strength have better anti-loosening properties. Taking 5–10 cycles of cyclic loading as a boundary, the pre-loading relaxation is divided into two stages. The first stage is a stage of rapid decrease in bolt pre-loading, and the second stage is the slow decrease process. The performance prediction study shows that the allometric model function is the worst fitted, at 71.7% for the small displacement condition. Other than that, the allometric model function and the nine-stage polynomial function can predict more than 85.5% and 90.4%, which require the use of least squares to identify two and ten unknown parameters, respectively. The complexity of the two is different, but both can by better indicators than the pre-loading relaxation law under specific conditions. It helps to improve the monitoring of bolt loosening and the system use cycle, and it can provide theoretical support for complex equipment working for a long time.

Method of accumulation of preload loss of bolted joints due to rotational self-loosening caused by cyclic, transversal excitation

Critical load determination for preventing rotational loosening in bolted joints under dynamic transverse loads

Analytical Modeling of Self-Loosening of Bolted Joints Subjected to Transverse Loading

Mechanical Behavior of Loose High-Strength Bolted Connections with Thin Sheet Steels

An analytically improved four-stage model for single-lap torqued bolted joints accounting for preload relaxation

Simulation of Preload Relaxation of Bolted Joint Structures under Transverse Loading

Determination of the Preload of Bolts for Structural Health Monitoring of a Multi-Bolted Joint: FEM Approach

Prediction of Pre-Loading Relaxation of Bolt Structure of Complex Equipment under Tangential Cyclic Load

Thin-layer element method for multi-stage rotor bolt loosening identification

Preload Monitoring of Bolted L-Shaped Lap Joints Using Virtual Time Reversal Method

A methodology for energy dissipation prediction of the bolt group with non-uniform preload

Modeling of Preload Bolted Flange Connection Structure for Loosening Analysis and Detection

Nonlinear Dynamic Analysis for a Jeffcott Rotor Considering Varying Connection Stiffness of Bolted Joint

Bolted Joint Preload Distribution from Torque Tightening

Degradation and failure analysis of bolted joints under transverse loading

Loosening and Strength Failure Calculation Models of Screwed Joints Under Complex Working Condition Loading

Numerical and experimental investigations on dynamic behaviors of a bolted joint rotor system with pedestal looseness

Measured and investigated nonlinear dynamics parameters on bolted flange joints of combined rotor

Clamp Load Loss due to Elastic Interaction and Gasket Creep Relaxation in Bolted Joints

Effect of preload distribution on dynamic characteristics of machine tool bolted joint structure

Experimental Studies of an Asymmetric Multi-Bolted Connection under Monotonic Loads