Feasibility study on utilisation of clay–waste tyre rubber mix as construction material

Jitendra Singh Yadav
DOI: https://doi.org/10.1680/jcoma.19.00114
2020-12-07
Abstract:This paper assesses the possibility of utilisation of clay–waste tyre rubber mixes as construction materials for geotechnical structures. Rubber granulates (R<sub>g</sub>) and rubber fibres (R<sub>f</sub>) were blended with  2.5, 5, 7.5 and 10% clay content. The various combinations of clay–rubber granulates (CR<sub>g</sub>) and clay–rubber fibres (CR<sub>f</sub>) were subjected to the sequence of compaction, strength, consolidation and swelling pressure tests. A linear decrementing trend of compaction parameters was observed with an increase in R<sub>g</sub> and R<sub>f</sub> contents. An insignificant rise in unconfined compressive strength (UCS) and splitting tensile strength (STS) of clay was observed with the addition of R<sub>g</sub> and R<sub>f</sub> up to 5 and 2.5%, respectively. Higher inclusions had reduced the UCS and STS of clay. However, a continual increase in failure strain was observed with an increase in R<sub>g</sub> and R<sub>f</sub> contents. The compression index of CR<sub>g</sub> and CR<sub>f</sub> mixtures was found to increase with the increase of R<sub>g</sub> and R<sub>f</sub> contents. A continuous decrease in the soaked California bearing ratio and swelling pressure (<i>σ</i><sub>s</sub>) of CR<sub>g</sub> and CR<sub>f</sub> mixtures was observed with the increase in R<sub>g</sub> and R<sub>f</sub> contents. In view of code requirements, the pre-requisite treatment of CR<sub>g</sub> and CR<sub>f</sub> mixtures should be carried out before field applications.
English Else
What problem does this paper attempt to address?