Alloyed Palladium–Silver Nanowires Enabling Ultrastable Carbon Dioxide Reduction to Formate

Na Han,Mingzi Sun,Yuan Zhou,Jie Xu,Chen Cheng,Rui Zhou,Liang Zhang,Jun Luo,Bolong Huang,Yanguang Li

DOI: https://doi.org/10.1002/adma.202005821

IF: 29.4

2020-12-04

Advanced Materials

Abstract:<p>Palladium can enable the electrochemical CO<sub>2</sub> reduction to formate with nearly zero overpotential and good selectivity. However, it usually has very limited stability owing to CO poisoning from the side reaction intermediate. Herein, it is demonstrated that alloying palladium with silver is a viable strategy to significantly enhance the electrocatalytic stability. Palladium–silver alloy nanowires are prepared in aqueous solution with tunable chemical compositions, large aspect ratio, and roughened surfaces. Thanks to the unique synergy between palladium and silver, these nanowires exhibit outstanding electrocatalytic performances for selective formate production. Most remarkably, impressive long‐term stability is measured even at < ‐0.4 V versus reversible hydrogen electrode where people previously believed that formate cannot be stably formed on palladium. Such stability results from the enhanced CO tolerance and selective stabilization of key reaction intermediates on alloy nanowires as supported by detailed electrochemical characterizations and theoretical computations.</p>

materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,nanoscience & nanotechnology

What problem does this paper attempt to address?

The paper attempts to address one of the main challenges faced by palladium (Pd) catalysts in the electrochemical carbon dioxide reduction reaction (CO2RR) when generating formate salts—poor stability. Specifically, although pure palladium catalysts can reduce CO2 to formate salts with near-zero overpotential and good selectivity, they are susceptible to CO poisoning, leading to rapid activity decline. This is especially true at potentials below -0.2 V (relative to the reversible hydrogen electrode, RHE), where the stability and activity of palladium catalysts significantly decrease. Therefore, the paper aims to improve the CO tolerance and long-term stability of palladium-based catalysts through an alloying strategy, thereby enhancing their performance in practical applications. To address this issue, the research team developed a method for preparing palladium-silver (Pd-Ag) alloy nanowires and investigated the electrocatalytic performance of these alloy nanowires in CO2RR. Experimental results show that Pd-Ag alloy nanowires can efficiently and selectively reduce CO2 to formate salts at lower overpotentials and exhibit excellent long-term stability, maintaining stable activity even at potentials below -0.4 V. Theoretical calculations further reveal how the introduction of silver modulates the electronic structure of palladium and weakens CO adsorption, thereby improving the catalyst's CO tolerance and selectivity.

Alloyed Palladium–Silver Nanowires Enabling Ultrastable Carbon Dioxide Reduction to Formate

Palladium–Silver Nanowires: Alloyed Palladium–Silver Nanowires Enabling Ultrastable Carbon Dioxide Reduction to Formate (Adv. Mater. 4/2021)

Mesoporous PdAg Nanospheres for Stable Electrochemical CO2 Reduction to Formate

A Gold–Palladium Nanoparticle Alloy Catalyst for CO Production from CO2 Electroreduction

Two-Dimensional Palladium–Copper Alloy Nanodendrites for Highly Stable and Selective Electrochemical Formate Production

Robust Palladium Hydride Catalyst for Electrocatalytic Formate Formation with High CO Tolerance

High-Dispersive Pd Nanoparticles on Hierarchical N-Doped Carbon Nanocages to Boost Electrochemical Co<sub>2</sub> Reduction to Formate at Low Potential

Intercalated Gold Nanoparticle in 2D Palladium Nanosheet Avoiding CO Poisoning for Formate Production under a Wide Potential Window

How palladium inhibits CO poisoning during electrocatalytic formic acid oxidation and carbon dioxide reduction

High‐Dispersive Pd Nanoparticles on Hierarchical N‐Doped Carbon Nanocages to Boost Electrochemical Co2 Reduction to Formate at Low Potential

Tuning the electron structure enables the NiZn alloy for CO2 electroreduction to formate

A nanoporous PdCo alloy as a highly active electrocatalyst for the oxygen-reduction reaction and formic acid electrooxidation.

Electrochemical Synthesis of Monodispersed and Highly Alloyed PtCo Nanoparticles with a Remarkable Durability Towards Oxygen Reduction Reaction

Dendritic Defect-Rich Palladium-Copper-Cobalt Nanoalloys As Robust Multifunctional Non-Platinum Electrocatalysts For Fuel Cells

Fine AgPd Nanoalloys Achieving Size and Ensemble Synergy for High‐Efficiency CO2 to CO Electroreduction

Surface Structure Engineering of PdAg Alloys with Boosted CO2 Electrochemical Reduction Performance

Stable CuIn Alloy for Electrochemical CO2 Reduction to CO with High-Selectivity

Engineering Bimetallic Copper‐Tin Based Core‐Shell Alloy@Oxide Nanowire as Efficient Catalyst for Electrochemical CO 2 Reduction

Boosting Formate Electrooxidation by Heterostructured PtPd Alloy and Oxides Nanowires

Hierarchical defective palladium-silver alloy nanosheets for ethanol electrooxidation

Monolithic Nanoporous In–Sn Alloy for Electrochemical Reduction of Carbon Dioxide