Abstract:This paper presents a monolithically integrated aptasensor composed of a piezoresistive microcantilever array and an on-chip signal processing circuit. Twelve microcantilevers, each of them embedded with a piezoresistor, form three sensors in a Wheatstone bridge configuration. The on-chip signal processing circuit consists of a multiplexer, a chopper instrumentation amplifier, a low-pass filter, a sigma-delta analog-to-digital converter, and a serial peripheral interface. Both the microcantilever array and the on-chip signal processing circuit were fabricated on the single-crystalline silicon device layer of a silicon-on-insulator (SOI) wafer with partially depleted (PD) CMOS technology followed by three micromachining processes. The integrated microcantilever sensor makes full use of the high gauge factor of single-crystalline silicon to achieve low parasitic, latch-up, and leakage current in the PD-SOI CMOS. A measured deflection sensitivity of 0.98 × 10 − 6 nm −1 and an output voltage fluctuation of less than 1 μV were obtained for the integrated microcantilever. A maximum gain of 134.97 and an input offset current of only 0.623 nA were acquired for the on-chip signal processing circuit. By functionalizing the measurement microcantilevers with a biotin-avidin system method, human IgG, abrin, and staphylococcus enterotoxin B (SEB) were detected at a limit of detection (LOD) of 48 pg/mL. Moreover, multichannel detection of the three integrated microcantilever aptasensors was also verified by detecting SEB. All these experimental results indicate that the design and process of monolithically integrated microcantilevers can meet the requirements of high-sensitivity detection of biomolecules.

Advanced Sensor Technology Based on Oxide Thin Film—MEMS Integration

Chemical Specificity in Nanomechanical Sensors

Mechanical and Electronic Approaches to Improve the Sensitivity of Microcantilever Sensors.

Simulation and Design of Piezoelectric Microcantilever Chemical Sensors

Micromechanical Sensors Based on Conformational Change of Proteins

Improved Surface Modification Approach for Micromechanical Biosensors

Chemical Sensors and Measurement

Microcantilever Biosensors for Chemicals and Bioorganisms

Molecular Recognition of Chem/Biowarfare Agents Using Micromechanical Sensors

Micromachined SiO 2 microcantilever for high sensitive moisture sensor

Microhotplates for Metal Oxide Semiconductor Gas Sensor Applications—Towards the CMOS-MEMS Monolithic Approach

Recent advancements in physical and chemical MEMS sensors

Fast-Response, Sensitivitive and Low-Powered Chemosensors by Fusing Nanostructured Porous Thin Film and IDEs-Microheater Chip

Application-specific sensor systems based on CMOS chemical microsensors

From Ceramic Tube to Microcantilever: A New Strategy for Low Power, Fast Heating and High Integrated Metal Oxide Semiconductor Gas Sensor

Multiple-input microcantilever sensors

Design And Fabrication Of An Integrated Mems O-2 Sensor Based On Nanostructured Tio2

A Monolithically Integrated Microcantilever Biosensor Based on Partially Depleted SOI CMOS Technology

Microcantilever-based platforms as biosensing tools

Integration of Metal-Oxide Nanobelts with Microsystems for Sensor Applications

A hybrid polymer/ceramic/semiconductor fabrication platform for high-sensitivity fluid-compatible MEMS devices with sealed integrated electronics