Abstract:Low alkaline liquid state setting accelerator(LSA) for Portland cement was prepared in laboratory from aqueous solution of several inorganic sulfate salts and some organic chemical substances. Properties of cement with addition of LSA relating to its setting time and strength development as well as its resistance to sulfate attack for short and long term exposure were experimentally examined. The experimental results showed that 5%–7% addition of LSA significantly accelerated the initial and final setting of Portland cement in the presence or absence of the blending of mineral admixtures, the initial and final setting time being less than 3 min and 6 min respectively. Meanwhile, the early 1 day curing age compressive strength increased remarkably by 20%, while the late 28th day curing age compressive strength remained almost unchanged as compared with that of the reference accelerator free cement mortar specimen. Furthermore, mortar specimens of cement added with LSA and exposed to 5% Na2SO4 solution showed their excellent resistance to sulfate attack, with their short and long term curing age resistance coefficient to sulfate attack being around 1.04 to 1.17, all larger than 1.0. XRD analysis on hardened cement paste specimens at very early curing ages of several minutes disclosed the existence of more ettringite in specimens added with LSA than that of the reference specimens, meanwhile SEM observation also revealed the existence of well crystallized ettringite at very early hydration stage, suggesting that the accelerated setting of Portland cement can be attributed to the early and rapid formation of ettringite over the whole cement paste matrix due to the introduction of LSA. MIP measurement revealed that hardened cement paste specimens with the addition of LSA presented less medium diameter pores, more proportion of small pores and less proportion of large capillary pores, which is in a very good coincidence with the improvement of strength development of cement mortars added with LSA.

A ultra‐low viscosity stearic acid emulsion prepared by lauric acid as waterproof agent for cement mortar

Experimental study on waterproof performance and freeze-thaw resistance of cement mortar using stearic acid modified mica powder

Effect of waterproof agent on performance of inorganic lightweight aggregate thermal insulating mortar

Study on Corrosion Resistance of Hydrophobic Early Strength Mortar Containing Calcium Formate

Preparation of a Stable Superhydrophobic Mortar Surface Using a One-Step Method

Influence of water-repellent admixtures ( Sitren and Stearate materials) on the microstructure and mechanical performance of conventional Portland cement paste and mortar

Mechanical Characterization of Polyacrylate Emulsion Modified Mortars

Study on PVA-siloxane mixed emulsion coatings for hydrophobic cement mortar

An eco-friendly and low-cost superhydrophobic alkali-activated Portland slag cement mortar

Erosion of Aerial Lime and Sticky Rice Mortars by Cyclic Wetting–drying and Dilute Sulfate Acid Actions

Chloride ion penetration resistance and microstructural modification of concrete with the addition of calcium stearate

Development of cementitious capillary crystalline waterproofing agents and durability study of concrete in the presence of chloride with sulfate in aqueous environment

Effect of Styrene-Acrylic Emulsion on Crack Resistance of Cement-Based Materials

Properties and acceleration mechanism of cement mortar added with low alkaline liquid state setting accelerator

Mechanical properties and anti-efflorescence of cement-based coating containing silicon-aluminum based powder and modified-polyacrylate emulsion

Hydration behaviour of cement in polymer cement waterproof coating and its effect on the macroscopic performance

Feasibility and Corrosion Inhibition Efficacy of Zeolite-Supported Lauric Acid Imidazoline As Corrosion Inhibitor in Cementitious Mortar

The Effect of Hydroxy Silicone Oil Emulsion on the Waterproof Performance of Cement

Effect of lime mud under wet grinding on the compressive strength and hydration of cement mortar

Comparison of stearic acid and oleic acid for shrinkage-mitigating of alkali-activated slag composites

Effects of styrene–acrylic emulsion on bond performance and interface microstructure of repair mortar of ternary cementitious system