Abstract:RAFT polymerization is a type of psudo-living radical polymerization. In order to synthesize high pure block copolymers by RAFT polymerization, it is desirable to suppress the irreversible termination which may result in the formation of dead chains. For polymers less than 5 x 10(4) g/mol, the dead chain fraction could remain to be lower than 0.1 by reducing the initiator concentration. In the synthesis of block copolymers, the dead chains formed in the first stage are actually contaminant. Targeting to the synthesis of high pure block copolymers with high molecular weight using RAFT polymerization, we studied the copolymerization of butyl acrylate and styrene mediated by 1-phenylethyl phenyl-dithioacetate (PEPDTA) as a RAFT agent. The influences of the type of initiators (AIBN (2-2'-azobis ( isobutyronitrile)), ACC ( 1-1'-azobis ( cyclohexane-carbonitrile)), the concentrations of initiator and polymerization temperature on the copolymerization kinetics and molecular weight and its distribution were investigated. When AIBN was used, the polymerization would stop at middle monomer conversion, which limited the increase of molecular weight of the copolymer if we reduced the initiator concentration. It was found that only with the initiator (ACC) with small decomposition rate constant and high polymerization temperature, the block copolymer with high molecular weight and small fraction of dead chains ( < 0.1) could be synthesized. The reason for these quite strict requirements is that the initiator concentration should remain far below that of the conventional radical polymerization, which is limited by the very low RAFT concentration.

Study on two different dithiobenzoates effectiveness in bulk RAFT polymerization of β-myrcene

Modeling and Experimentation of RAFT Solution Copolymerization of Styrene and Butyl Acrylate, Effect of Chain Transfer Reactions on Polymer Molecular Weight Distribution

Toward Understanding of Branching in RAFT Copolymerization of Methyl Methacrylate Through a Cleavable Dimethacrylate

INFLUENCE OF MONOMER COMPOSITION ON THE CHAIN TRANSFER COEFFICIENT IN METHYL METHACRYLATE/BUTYL ACRYLATE RAFT COPOLYMERIZATION

Ab initio RAFT emulsion polymerization of butadiene using the amphiphilic poly(acrylic acid-b-styrene) trithiocarbonate as both surfactant and mediator

RAFT miniemulsion polymerization of methyl methacrylate

Toward well-controlled ab initio RAFT emulsion polymerization of styrene mediated by 2-(((Dodecylsulfanyl)carbonothioyl)sulfanyl)propanoic acid

RAFT Ab Initio Emulsion Copolymerization of Γ-Methyl-α-methylene-γ-butyrolactone and Styrene

The Synthesis of High Molecular Weight Block Copolymers by Raft Polymerization

Butyl Acrylate RAFT Polymerization in Miniemulsion

Study on Kinetics of Controlled/living Radical Polymerization of Acrylonitrile by RAFT Technique

Particle activation/deactivation effect in RAFT emulsion polymerization of styrene

Reversible addition fragmentation transfer (RAFT) polymerization of styrene in a miniemulsion: A mechanistic investigation

Kinetics of methyl methacrylate and n-butyl acrylate copolymerization mediated by 2-cyanoprop-2-yl dithiobenzoate as a RAFT agent

Ab Initio RAFT Emulsion Copolymerization of Styrene and Acrylonitrile

Suppressing the Long‐chain Branching in the Synthesis of Poly(styrene‐b‐butyl Acrylate‐b‐styrene) in RAFT Emulsion Polymerization by Tuning the Interfacial Properties

Atom Transfer Radical Polymerization of Styrene with 2‐(1‐bromoethyl)‐anthraquinone As an Initiator

Kinetics of RAFT Emulsion Polymerization of Styrene Mediated by Oligo(acrylic Acid‐b‐styrene) Trithiocarbonate

2‐Cyanopropan‐2‐yl versus 1‐Cyanocyclohex‐1‐yl Leaving Group: Comparing Reactivities of Symmetrical Trithiocarbonates in RAFT Polymerization

Synthesis and MALDI-TOF Characterization of Β -CD Core ATRP Initiators and RAFT Chain Transfers with Different Degrees of Substitution

Self-Catalyzed Hydrolysis of Nitrile-Containing RAFT Chain-Transfer Agent and Its Impact upon Polymerization Control of Methacrylic Monomers