Abstract:Phosphogypsum, a typical by-product in the phosphorus chemical industry, could generate a large amount of leachate containing phosphate and fluoride in the process of rainfall and long-term stacking, which not only causes serious environmental pollution, but also leads to a waste of resources. In this study, a united treatment of calcium hydroxide precipitation and lanthanum zeolite (La-ZFA) adsorption was proposed to achieve the recovery of phosphate and fluoride from phosphogypsum leachate. In phosphogypsum, most phosphorus could be leached except P in the residual occurrence form, while for fluoride, only water-soluble F could be effectively leached. The optimum leaching amounts of phosphate and fluoride were 22.59 and 4.64 mg/g, respectively, at liquid-solid ratio of 400:1, leaching time of 120 min, pH of 6.0, particle size of >200 mesh (<0.075 mm), and leaching temperature of 25°C. Using Ca(OH)2 as the precipitant, the phosphate could be precipitated selectively from phosphogypsum leachate by controlling pH and time, and the concentrations of it decreased significantly to 0.29 mg/L at pH 10.0, with a removal efficiency of 99.48%. XRD, SEM and Visual MINTEQ software analysis proved that the main component of the precipitate was hydroxyapatite (Ca5(PO4)3(OH)). After P precipitation, a series of sorbents for fluoride were investigated, and La-ZFA sorbent was chosen and utilized to recover the fluoride from the leachate through a cyclic fixed-bed column. The efficiency of La-ZFA was basically not affected by the high concentration sulfate, and it can selectively adsorb fluoride from phosphogypsum leachate, leading to a final fluoride concentration of 0.29 mg/L in the effluent. The characterization demonstrated that fluoride might be adsorbed onto the La-ZFA via ligand exchange with hydroxy groups. The proposed method in this study is expected to sequentially recover phosphate and fluorine from the leachate of phosphogypsum, and it has great guiding significance for resource utilization and management of phosphogypsum.

Characterization and treatment of the phosphoric gypsum transport water

A Precipitation-Adsorption Technique for the Removal of Fluoride and Phosphate in Phosphogypsum: an Economical and Green Method

Research on the technology and mechanism of direct acidification of phosphogypsum and deeply solidify impurities with lime

Treatment and Purification of Phosphogypsum

Study of Semi-Dry High Target Solidification/Stabilization of Harmful Impurities in Phosphogypsum by Modification

Harmless treatment technology of phosphogypsum: Directional stabilization of toxic and harmful substances

Highly efficient recovery of phosphate and fluoride from phosphogypsum leachate: Selective precipitation and adsorption

Staged purification of phosphogypsum using pH-dependent separation process

Simultaneous removal of phosphorus and organic contaminants from phosphogypsum using hydrothermal method for gypsum resource regeneration

Treating waste phosphogypsum for cement and plaster manufacture

Multi-stage precipitation for the eco-friendly treatment of phosphogypsum leachates using hybrid alkaline reagents

Optimization of wet-process phosphoric acid for high-quality phosphogypsum

Characterisation of Purified Gypsum and Insoluble Impurities Obtained from Phosphogypsum Waste

Extraction and transformation of elements in phosphogypsum by electrokinetics

Valorisation diagnosis of waste from the decontamination of phosphogypsum leachates through a combined calcium carbonate/hydroxide process

Influence of Impurities on the Process of Obtaining Calcium Carbonate during the Processing of Phosphogypsum

Highly targeted solidification behavior of hazardous components in phosphogypsum

Highly targeted stabilization and release behavior of hazardous substances in phosphogypsum

Deep removal of phosphorus and synchronous preparation of high-strength gypsum from phosphogypsum by crystal modification in NaCl-HCl solutions