Abstract:Phosphogypsum, a typical by-product in the phosphorus chemical industry, could generate a large amount of leachate containing phosphate and fluoride in the process of rainfall and long-term stacking, which not only causes serious environmental pollution, but also leads to a waste of resources. In this study, a united treatment of calcium hydroxide precipitation and lanthanum zeolite (La-ZFA) adsorption was proposed to achieve the recovery of phosphate and fluoride from phosphogypsum leachate. In phosphogypsum, most phosphorus could be leached except P in the residual occurrence form, while for fluoride, only water-soluble F could be effectively leached. The optimum leaching amounts of phosphate and fluoride were 22.59 and 4.64 mg/g, respectively, at liquid-solid ratio of 400:1, leaching time of 120 min, pH of 6.0, particle size of >200 mesh (<0.075 mm), and leaching temperature of 25°C. Using Ca(OH)2 as the precipitant, the phosphate could be precipitated selectively from phosphogypsum leachate by controlling pH and time, and the concentrations of it decreased significantly to 0.29 mg/L at pH 10.0, with a removal efficiency of 99.48%. XRD, SEM and Visual MINTEQ software analysis proved that the main component of the precipitate was hydroxyapatite (Ca5(PO4)3(OH)). After P precipitation, a series of sorbents for fluoride were investigated, and La-ZFA sorbent was chosen and utilized to recover the fluoride from the leachate through a cyclic fixed-bed column. The efficiency of La-ZFA was basically not affected by the high concentration sulfate, and it can selectively adsorb fluoride from phosphogypsum leachate, leading to a final fluoride concentration of 0.29 mg/L in the effluent. The characterization demonstrated that fluoride might be adsorbed onto the La-ZFA via ligand exchange with hydroxy groups. The proposed method in this study is expected to sequentially recover phosphate and fluorine from the leachate of phosphogypsum, and it has great guiding significance for resource utilization and management of phosphogypsum.

Multi-stage precipitation for the eco-friendly treatment of phosphogypsum leachates using hybrid alkaline reagents

A Precipitation-Adsorption Technique for the Removal of Fluoride and Phosphate in Phosphogypsum: an Economical and Green Method

Moderately efficient leaching of rare earth elements from phosphogypsum via crystal regulation with EDTA-2Na during gypsum phase transformation and recovery by precipitation

Staged purification of phosphogypsum using pH-dependent separation process

Recyclable and Efficient Recovery of Ca and S from Phosphogypsum by Using Multistep Precipitation

Efficient precipitation of soluble phosphorus impurities in the recycling of phosphogypsum to produce hemihydrate gypsum

Highly efficient recovery of phosphate and fluoride from phosphogypsum leachate: Selective precipitation and adsorption

Deep removal of phosphorus and synchronous preparation of high-strength gypsum from phosphogypsum by crystal modification in NaCl-HCl solutions

Highly targeted stabilization and release behavior of hazardous substances in phosphogypsum

The leaching characteristics of common toxic elements in phosphogypsum

Phosphorus recovery and resource utilization from phosphogypsum leachate via membrane-triggered adsorption and struvite crystallization approach

Efficient extraction of impurities from phosphogypsum during crystal regulation of α‐hemihydrate gypsum

Harmless treatment technology of phosphogypsum: Directional stabilization of toxic and harmful substances

Research on the technology and mechanism of direct acidification of phosphogypsum and deeply solidify impurities with lime

Simultaneous removal of phosphorus and organic contaminants from phosphogypsum using hydrothermal method for gypsum resource regeneration

Study of Semi-Dry High Target Solidification/Stabilization of Harmful Impurities in Phosphogypsum by Modification

Characteristic pollutant purification analysis of modified phosphogypsum comprehensive utilization

Extraction and transformation of elements in phosphogypsum by electrokinetics

Simultaneous immobilizations of soluble phosphorus and fluorine in phosphogypsum by milling with calcareous and aluminiferous samples: Reaction products and immobilization performances

Leaching behavior and release mechanism of pollutants from different depths in a phosphogypsum stockpile

Environmental assessment of phosphogypsum: A comprehensive geochemical modeling and leaching behavior study