Abstract:Topology optimization of dynamic response is a matter that is engaging practitioners and researchers since a few decades. Issues that have been (at least partially) successively solved include minimization methods, filtering, stress constraints and robustness with respect to load and material uncertainty, among others. Within this scenario, the Additive Manufacturing technology offers a huge variety of new possibilities as to material properties and overall structures that are designed using topology optimization. On the other side, entirely new challenges emerge that have started being faced only recently by the scientific community that are most times multidisciplinary. This paper addresses the following two issues: 1. from a mechanical standpoint, the H∞-norm-based approach developed in [1] is extended to improve printability of the optimal design. This is achieved by adopting an extended formulation that explicitly includes a constraint on the maximum allowable overhang of the optimal topology; 2. newly conceived composite materials are considered such as those recently proposed in [2] and [3]. It is to be noted that chemical research is in fact providing new materials for novel applications nearly every day. As for mechanical properties of the composite, fibers are traditionally deposited along a pre-selected direction [3] and the resulting overall mechanical modulus computed as a convex combination of the matrix and fibers moduli. It is planned to exploit the effect of using fibers of variable orientation so as to end up with and increased stiffness at the overall structural level. A numerical application on a benchmark problem (the MMB beam) shall be addressed and the optimal numerical solution computed. An insight into the actual manufacturability of the numerical model will be given as well along with preliminary experimental results.

Integration of additive manufacturing process-induced material characteristics into topology optimization

Self-supporting Topology Optimization for Additive Manufacturing

Discrete Multi-Material Topology Optimization under Total Mass Constraint

Topology Optimisation of Self-Supporting Structures Based on the Multi-Directional Additive Manufacturing Technique

Topology Optimization of Multi-Material Structures with Explicitly Graded Interfaces

Additive manufacturing-driven design optimization: Building direction and structural topology

Topology Optimization of Multi-Material Structures Considering Anisotropic Yield Strengths

Topology optimization including a model of the layer-by-layer additive manufacturing process

Topology Optimization of Dynamic Response : Methods , Materials and Additive Manufacturing ( Sim-AM 2019 )

A post-topology optimization process for overhang elimination in additive manufacturing: design workflow and experimental investigation

A multiobjective topology optimization approach for cost and time minimization in additive manufacturing

Boundary Slope Control in Topology Optimization for Additive Manufacturing: For Self-Support and Surface Roughness

Consistent machine learning for topology optimization with microstructure-dependent neural network material models

Combination of topology and shape optimization with finite element modeling in the case of an aerospace component produced by laser based additive manufacturing

Topology Optimization of Fibre Reinforced Polymer Lattice Structures for Additive Manufacturing

Topology Optimization of Thermal Conductive Support Structures for Laser Additive Manufacturing

Topology optimization of extreme mechanical metamaterials considering the anisotropy of additive manufactured parts

A review of topology optimization for additive manufacturing: Status and challenges

Concurrent topology optimization of parts and their supports for additive manufacturing with thermal deformation constraint

Topology optimization accounting for surface layer effects

Topology optimization of multi-phase shell-infill composite structure for additive manufacturing