Abstract:Wastewater treatment based on activated sludge processes faces a major challenge due to an increased number of people contributing to wastewater and changes in wastewater characteristics in regions with seasonal winter tourism. The combination of significant increases in carbon (COD) and nitrogen (N) loads by a factor of four to five within a short periode of time and low wastewater temperatures (<12 °C), represents a bottleneck in meeting essential effluent requirements. According to literature research, however, little attention has been paid to these special framework conditions for wastewater treatment. Based on this fact, a model-based simulation study of the wastewater treatment plant (WWTP) in Montafon (Austria) evaluates operational optimization approaches for the above-mentioned framework conditions and is intended to provide new insights for nitrification-optimized and energy-optimized wastewater treatment. The WWTP Montafon is designed for a COD load of 6250 kg d −1 , a daily dry weather water discharge of 12,700 m 3 d −1 and is a typical plant in a winter tourism region. The 5 studied smart operation approaches shown are a combination of two different aeration control strategies based on a time-controlled (i) or ammonia-based feedback aeration control (ABAC) (ii) for intermittent nitrification-denitrification and sludge removal control strategies based on a constant sludge concentration to 3 g L −1 (iii), a constant sludge retention time (SRT) to 20 days (iv) and a constant sludge retention time to 20 days combined with a higher level sludge concentration control to max. 3 g L −1 (v). The simulation results show that a combination of a time-controlled aeration strategy and controlling the sludge concentration to a constant 3 g L −1 is not recommended in order to comply with the emission limits. Under the mentioned influent conditions, ABAC control alone does not inevitably lead to a nitrification-optimized process and reduction in energy consumption. Sufficient nitrifying bacteria in the activated sludge are the key to a nitrification optimized process and reduction of energy consumption for aeration. Hence, a combination of an intermittent aeration control based on ammonium measurement and a constant sludge retention time to 20 days is preferable for nitrification capacity and is the most energy-efficient control strategy to obtain required COD and N effluent quality. An average energy consumption of 57–63 Wh PE 120 −1 d −1 for the aeration is to be expected for combinations of (i,iv), (ii, iii) (ii,iv) and (ii,v) which is low in relation to the influent challenges and to plants with higher wastewater temperatures (>12 °C) between 27 Wh PE 120 −1 d −1 and 121 Wh PE 120 −1 d −1 according to literature. The approach with a time-controlled intermittent aeration and a SRT to constant 20 days was implemented at the WWTP Montafon and confirms the results of the associated simulation. According to this simulation study, a 35 % increase in nitrification capacity in existing WWTPs designed as activated sludge processes can be achieved through optimized operating conditions without additional high investments.

Lag phase, dynamic alpha factor and ammonium adsorption behaviour: introduction of special activated sludge characteristics in the ASM3 + EAWAG-BioP-model

Impact of oxygen transfer dynamics on the performance of an aerobic granular sludge reactor

Modelling the impacts of operational conditions on the performance of a full-scale membrane aerated biofilm reactor

Simulation and optimization of ammonia removal at low temperature for a double channel oxidation ditch based on fully coupled activated sludge model (FCASM): a full-scale study.

Enhanced Biological Nutrient Removal in Sequencing Batch Reactors Operated As Static/oxic/anoxic (SOA) Process

Optimization of biological nitrogen removal in full-scale municipal WWTPs using activated sludge model simulation

A three-phase Eulerian–Lagrangian model to simulate mixing and oxygen transfer in activated sludge treatment

Modelling and set-point definition for the development of a joint control system of two interconnected wastewater treatment plants and its application in practice

Steady-State Methodology for Activated Sludge Model 1 (ASM1) State Variable Calculation in MBR

Modeling and Simulation of the Sequencing Batch Reactor at a Full‐scale Municipal Wastewater Treatment Plant

Plant-wide modelling of phosphorus transformations in wastewater treatment systems: Impacts of control and operational strategies

A novel metabolic-ASM model for full-scale biological nutrient removal systems

Enhanced ammonium removal from liquid anaerobic digestion residuals in an advanced sequencing batch reactor system

Model-based dynamic simulation study to boost the WWTP performance in winter tourism regions

Modelling biological phosphorus and nitrogen removal in a full scale activated sludge process

Optimizing anammox capacity for weak wastewater in an AnSBBR using aerobic activated sludge as inoculation

A plant-wide energy model for wastewater treatment plants: application to anaerobic membrane bioreactor technology

Integrated anaerobic and algal bioreactors: A promising conceptual alternative approach for conventional sewage treatment

Partial Nitrification and Enhanced Biological Phosphorus Removal in a Sequencing Batch Reactor Treating High-Strength Wastewater

A kinetic modeling for carbon metabolism in sequencing batch reactor under multiple aerobic/anoxic conditions

Nutrient Removal, Microbial Community and Sludge Settlement in Anaerobic/aerobic Sequencing Batch Reactors Without Enhanced Biological Phosphorus Removal.