Abstract:A portable electronic personal dosimeter (EPD) with a battery supply is widely used to monitor the dose equivalence of staff in nuclear radiation environments, requiring both a low energy detection limitation and a long operation period. Recently, a commercial silicon p-i-n (Si-PIN) detector has been proposed as a radiation sensor due to its advantages of low cost and high sensitivity. However, such a detector suffers from a large parasitic capacitance, i.e., 20 pF at a supply of several tens of volts. Thus, designing a low-noise front-end readout application-specific integrated circuit (ASIC) at low power dissipation is very critical. In this article, we propose design techniques and characterization of a fully customized low-noise ASIC for this application. An improved charge-sensitive amplifier (CSA) and a CR-(RC)(3) pulse shaper with programmable shaping time are proposed to achieve both a low noise floor and a smaller slope of equivalent noise charge (ENC) at room temperature. A four-channel ASIC has been successfully developed in the 0.35 mu m complementary metal oxide semiconductor (CMOS) process. The die size of the prototype chip is 2.5 x 2.5 mm. The dynamic range of input charges is 0.2-15 fC. The ENC is 102 + 3.5 e(-) (rms) per picofarad under a power dissipation of similar to 2 mW/channel. Through the measurement of the ASIC connected to a Si-PIN detector, the energy resolution is 3.8% full-width half maximum (FWHM) at the 59.5 keV of the radioactive source 241 Am. The energy detection threshold is less than 5 keV and the maximum count rate is 320 kcps. The proposed ASIC has passed the verification of a stereotyped EPD.

Low-cost open-source high-frequency portable pulse counter for Raspberry Pi and its application to Xray transmission rate measurement

Low-cost photoplethysmograph solutions using the Raspberry Pi

Open-Source Low-Cost Wireless Potentiometric Instrument for Ph Determination Experiments

OpenDosimeter: Open Hardware Personal X-ray Dosimeter

Design of a Low-Noise Photon-Count Readout ASIC for Si-PIN-Based Personal Dosimeters with Low Energy Detection Threshold

Arduino-Based Readout Electronics for Nuclear and Particle Physics

SENSROC12: A Four-Channel Binary-Output Front-End Readout ASIC for Si-PIN-Based Personal Dosimeters

RFSoC-based front-end electronics for pulse detection

A Multichannel High-Precision Pulse Counting System Based on FPGA

Low-cost wireless smart device design for radiation protection and nuclear security

[Portable Pulse Detection System Based on IoT]

A portable Raspberry Pi-based spectrometer for on-site spectral testing

Low-Cost High-Resolution Potentiostat for Electrochemical Detection of Nucleic Acids and Biomolecular Interactions

Design and Development of a Low Cost Pulse Oximeter

A Low-Cost FMCW Reader for High-Speed Interrogation of Chipless RFID Sensor

The Use of Raspberry Pi and High Resolution Sound Card for Very Low Frequency Signal Detection

High resolution stopwatch for cents

The Development of Linear Temperature Distribution Online Measurement Instrument Based on Raspberry Pi

White Rabbit Time Synchronization for Radiation Detector Readout Electronics

A high-speed and 8-channel counter based on FPGA