Abstract:In this manuscript we introduce cubic bubbles that are pinned to 3D printed millimetric frames immersed in water. Cubic bubbles are more stable over time and space than standard spherical bubbles, while still allowing large oscillations of their faces. We found that each face can be described as a harmonic oscillator coupled to the other ones. These resonators are coupled by the gas inside the cube but also by acoustic interactions in the liquid. We provide an analytical model and 3D numerical simulations predicting the resonance with a very good agreement. Acoustically, cubic bubbles prove to be good monopole sub-wavelength emitters, with non-emissive secondary surfaces modes.
What problem does this paper attempt to address?
The problem that this paper attempts to solve is the stability and size control of traditional underwater spherical bubbles in experiments. Specifically, spherical bubbles are difficult to remain stable in space due to buoyancy, and are prone to gas dissolution due to capillary over - pressure caused by surface curvature, thus affecting their long - term stability. These problems limit the application of spherical bubbles in the design of acoustic metamaterials.
To solve these problems, the author introduced a new bubble structure - the cubic bubble. This kind of bubble is fixed in water by a 3D - printed frame and has flat surfaces, thus eliminating capillary over - pressure and improving the stability and vibration amplitude of the bubble. The main objective of the paper is to study the acoustic properties of these cubic bubbles, especially their performance as acoustic resonators.
### Main research contents
1. **Design and preparation of cubic bubbles**:
- Use 3D printing technology to make a cubic frame. The internal dimension \(2a\) can vary between 0.9 and 2.1 millimeters, and the edge dimension \(e\) is 0.5 millimeters.
- The surface of the frame is silanized to make it hydrophobic and enhance the stability of the bubble.
2. **Acoustic property measurement**:
- Slowly immerse the cubic frame into deionized water to form six water - air interfaces.
- Use an underwater speaker to excite the bubble and record the sound pressure signal of the bubble under pulse excitation.
- Analyze the sound pressure signal by Fourier transform and extract the resonance frequency.
3. **Theoretical model and numerical simulation**:
- Propose a six - coupled - oscillator model. Each face can be regarded as a resonator, which is coupled through gas and liquid.
- Derive the analytical expression of the resonance frequency:
\[
f_{\text{res}}=\frac{1}{2\pi}\sqrt{\frac{N\kappa P_0\pi^2a^4/V_g}{\frac{32}{15}\rho_l a^3+(N - 1)\Delta m}}
\]
where \(N\) is the number of open faces, \(\kappa\) is the polytropic index of the gas, \(P_0\) is the gas pressure, \(V_g\) is the gas volume, \(\rho_l\) is the liquid density, and \(\Delta m\) is the effective mass increment of each face.
4. **Experimental verification**:
- The experimental results are compared with the theoretical model and 3D finite - difference time - domain (FDTD) simulation results to verify the accuracy of the model.
- The influence of different numbers of open faces on the resonance frequency is studied. It is found that as the number of open faces increases, the resonance frequency changes, which verifies the prediction of the coupled - oscillator model.
### Conclusion
As a new type of acoustic resonator, the cubic bubble has good stability and a high quality factor, and is suitable for the design of sub - wavelength acoustic metamaterials. Compared with traditional spherical bubbles, the cubic bubble is fixed by a 3D - printed frame, avoiding the influence of buoyancy and capillary effects, and showing better long - term stability. Future work will focus on studying the interaction between a large number of cubic bubbles, paving the way for the precise design of acoustic metamaterials.