Abstract:With the rapid development and broad applications of unmanned aerial vehicle (UAV)-based wireless stations in the sky, fundamental understanding and characterization of the realistic air-to-ground (A2G) communication link properties are crucial. In this article, a UAV-aided channel sounder with a real-time processing hardware system is developed for highly dynamic and nonstationary A2G channel measurements. In the hardware system, a global positioning system (GPS)-based triggering signal is designed, the equivalent antenna pattern affected by the UAV airframe is considered, and an appropriate sounding signal is selected, to improve the accuracy of measured channel impulse response (CIR). Moreover, real-time hardware processing algorithms for raw channel data, that is, CIR extraction, system response elimination (SRE), power loss recovery (PLR), and adaptive multipath component (MPC) recognition are developed and implemented on a single field-programmable gate array (FPGA) chip. In this way, the required storage size of channel data and the processing time for one slice of CIR is greatly decreased, which can meet the requirement of nonstationary A2G channel measurement with a high sampling rate and long-time measurement. A commercial channel emulator is used to reproduce controllable channels and verify the performance of the developed channel sounder. Finally, the developed channel sounder is applied to carry out A2G measurement campaigns at 3.5 GHz in a campus scenario. The channel characteristics, that is, path loss (PL), -factor, and path angle are analyzed. The measured channel characteristics are consistent with existing measurements under a similar scenario. The estimated path angles are also validated by the theoretical results. Thus, the channel sounder can be used to capture the nonstationary A2G channel characteristics for the system design and algorithm optimization of A2G commun- cations.

Ultra-Wideband Air-to-Ground Propagation Channel Characterization in an Open Area

UWB Channel Sounding and Modeling for UAV Air-to-Ground Propagation Channels

Ground-to-UAV sub-Terahertz channel measurement and modeling

Three-Dimensional Non-Stationary Geometry-Based Modeling of Sub-THz MIMO Channels for UAV Air-to-Ground Communications.

An UAV-based Experimental Setup for Propagation Characterization in Urban Environment

A UAV-Aided Real-Time Channel Sounder for Highly Dynamic Nonstationary A2G Scenarios

Characterizing the UAV-to-Machine UWB Radio Channel in Smart Factories

Path Loss Measurement And Modeling For Low-Altitude Uav Access Channels

An Experimental mmWave Channel Model for UAV-to-UAV Communications

Channel Model in Urban Environment for Unmanned Aerial Vehicle Communications

Ray-tracing Simulation and Hybrid Channel Modeling for Low-Terahertz UAV Communications

Experimental Characterization of Air-to-ground Propagation at mm-Wave Frequencies in Dense Urban Environment

The UWB Through-Wall Propagation Channel Measurement and Analysis from 1ghz to 2Ghz

An Empirical Air-to-Ground Channel Model Based on Passive Measurements in LTE

Empirical Dynamic Modeling for Low-Altitude UAV Propagation Channels

Propagation Characteristics of Air-to-Air Channels in Urban Environments.

Emulating UAV Motion by Utilizing Robotic Arm for mmWave Wireless Channel Characterization

Cluster-based Characterization and Modeling for UAV Air-to-Ground Time-Varying Channels

Analytical Modeling of UAV-to-Vehicle Propagation Channels in Built-Up Areas

220 GHz Urban Microcell Channel Measurement and Characterization on a University Campus