Abstract:We study the viscous-fingering instability in a radial Hele-Shaw cell in which the top boundary has been replaced by a thin elastic sheet. The introduction of wall elasticity delays the onset of the fingering instability to much larger values of the injection flow rate. Furthermore, when the instability develops, the fingers that form on the expanding air–liquid interface are short and stubby, in contrast with the highly branched patterns observed in rigid-walled cells (Pihler-Puzović et al. , Phys. Rev. Lett. , vol. 108, 2012, 074502). We report the outcome of a comprehensive experimental study of this problem and compare the experimental observations to the predictions from a theoretical model that is based on the solution of the Reynolds lubrication equations, coupled to the Föppl–von-Kármán equations which describe the deformation of the elastic sheet. We perform a linear stability analysis to study the evolution of small-amplitude non-axisymmetric perturbations to the time-evolving base flow. We then derive a simplified model by exploiting the observations (i) that the non-axisymmetric perturbations to the sheet are very small and (ii) that perturbations to the flow occur predominantly in a small wedge-shaped region ahead of the air–liquid interface. This allows us to identify the various physical mechanisms by which viscous fingering is weakened (or even suppressed) by the presence of wall elasticity. We show that the theoretical predictions for the growth rate of small-amplitude perturbations are in good agreement with experimental observations for injection flow rates that are slightly larger than the critical flow rate required for the onset of the instability. We also characterize the large-amplitude fingering patterns that develop at larger injection flow rates. We show that the wavenumber of these patterns is still well predicted by the linear stability analysis, and that the length of the fingers is set by the local geometry of the compliant cell.

Extensive tip-splitting of injected organic liquid into an aqueous viscoelastic fluid

Extensive tip-splitting of injected organic liquid into an aqueous viscoelastic fluid

Immiscible liquid-liquid displacement flows in a Hele-Shaw cell including shear thinning effects

Viscous Fingering Dynamics and Flow Regimes of Miscible Displacements in a Sealed Hele-Shaw Cell

Fingering instabilities of a reactive micellar interface

Controlling viscous fingering instabilities of complex fluids

Fingering to fracturing transition in a transient gel

Impact of surfactant addition on non-Newtonian fluid behavior during viscous fingering in Hele-Shaw cell

Viscous fingering in a radial elastic-walled Hele-Shaw cell

Three-Dimensional Roll-Up of A Viscoelastic Mixing Layer

Multiphase Viscoplastic Flows in a Nonuniform Hele-Shaw Cell: A Fluidic Device to Control Interfacial Patterns

Fingering instability in dewetting capillary nanosuspensions

Research on the Interfacial Instability of Non-Newtonian Fluid Displacement Using Flow Geometry

Compression-driven viscous fingering in a radial Hele-Shaw cell

Viscous Fingering in Multiport Hele Shaw Cell for Controlled Shaping of Fluids

The enhancement of viscous fingering with bidisperse particle suspension

Splitting morphology of low-viscous finger at different junctions of microchannels

Numerical study on the characteristics of viscous fingering during the displacement process of non-Newtonian fluid

Liquid Transfer for Viscoelastic Solutions

Fluid Mixing from Viscous Fingering

Effect of sinusoidal injection velocity on miscible viscous fingering of a finite sample: Nonlinear simulation