Design of Embedded Industrial robot based on PLC servo control
Yu-han Jie
DOI: https://doi.org/10.2991/EMCPE-16.2016.3
2016-08-27
Abstract:In order to improve the automation degree of robot, design size of the robot is reduced, a new industrial robot has been designed using PLC, servo motor drive and servo motor as the core component, through the PLC programming and the Modbus communication. IPC and Delta PLC of this kind of robot uses RS232 serial port and communication mode of ASCII protocol to control servo motor, force control software and servo driver use Modbus protocol communication mode for real-time monitoring of motor movement state. Through the PLC programming, the positioning function of the industrial robot servo motor is realized. Finally, the system positioning accuracy is higher after the debugging and running, which can meet the requirements for embedded industrial robot design. Introduction Servo motor is one of the most commonly used control devices in the industrial robot automation control system. Because the servo motor has fast response and high control precision, which is used in many automatic control occasions. It will promote the level of automatic control and remote monitoring system that combining the servo motor and bus communication control technology. Now the industrial automation control has changed from the single chip microcomputer control to the integrated control system. With the arrival of network times, it provides a great convenience to the industrial automation control network. Modbus communication protocol is one of the protocols of industrial control network. Through this protocol, the network can be used to connect the controller, the communication between the systems is realized. It will effectively improve the control efficiency and accuracy of the robot if Modbus communication and PLC program has embedded in the industrial robot control system. PLC communication control of embedded industrial robot Communication is the foundation of realizing the automation control of embedded industrial robot, the embedded industrial robot based on PLC programming is communicated mainly by two ports CN2 and CN3, the communication principle of CN2 port is shown in Fig.1. 5th International Conference on Environment, Materials, Chemistry and Power Electronics (EMCPE 2016) © 2016. The authors Published by Atlantis Press 11 Fig.1 Schematic diagram of CN2 port Servo motor driver CN2 is the encoder signal interface of motor speed, ECMA servo motor driver series has a built-in encoder, its form as shown in Fig.1, which is 2500pprA, B, Z, U, V, W. When the power is started, the signal in the way of six kinds of U+, V+, W+, U-, V-, Wto inform the servo motor drive in 0.5 seconds, and then six lines are replaced by A+, B+, Z+, A-, B-, Zsignals. The encoder signal interface has a total of 10 lines plus the two power line and two wires. Fig.2 The CN3 port CN3 is the communication interface of the servo motor driver, which is used to connect the servo motor and the computer by the driver, and the special software is used to communicate with the computer by MODBUS protocol. This type of driver provides three communication modes, including RS-232, RS-485, RS-42, which can use (P3-05) to set. The RS-232 serial communication is used in the paper, which can feedback the motor speed and other motion state in the form of signal, its wiring is shown in Fig.3. Fig.3 Schematic diagram of Modbus communication
Engineering,Computer Science