Abstract:A 600-700GHz SIS mixer with the twin-junction tuning circuit has been designed and fabricated [1] The surface impedance of thin-film superconducting microstrip lines, based on Mattis-Bardeen theory [2], is included in the optimization of RF impedance matching. The receiver noise temperature measured in the frequency range of 630-660GHz is below 200K and the lowest receiver noise temperature of 181K is achieved at 656GHz. The FTS response of the SIS mixer shows a good RF coupling from 600GHz to 700GHz. Both the noise performance and the FTS response can be quantitatively described by numerical results using the quantum theory of mixing. Some detail considerations on the mixer model calculation, such as spreading inductance around the junction tuning structure and mixer's embedding impedance, are discussed. Introduction Nb-based superconductor-insulator-superconductor (SIS) mixers have been used very successfully in sub-mm wavelength detection. Their receiver noise temperature has reached to three times the quantum limit, —3 hfrkB, below the junction's gap frequency. However, at high frequency bands, Nb SIS mixers need to be designed carefully because the photon energy is close to or higher than the gap energy of Nb, A-1.4meV. When the frequency band covers the gap frequency of Nb, —670GHz, the RF loss of Nb superconducting transmission lines increases dramatically and the surface impedance has strong frequency dependence. Usually, the RF properties of a superconducting transmission line can be described by the Mattis-Bardeen theory [2] in good accuracy. From results reported so far [4-9], the best receiver noise temperature is close to 5 hi7kB in the band of 600-700GHz. Despite of the input loss contributed by the experimental setup, some other properties of SIS mixers should be taken into account. In this paper, we characterize the performance of a 600-700GHz mixer by comparing the experimental and simulated results.

Superconducting Matching Circuits for an Oscillator and an SIS Mixer in the Subterahertz Frequency Range

Millimeter wave and sub-millimeter wave circuits for integrated system-on-a-chip

Performance Characterization of a 600-700 GHz SIS Mixer

THE DESIGN OF SUPERCONDUCTOR MIXER AT 500Ghz

Shunted Josephson Junctions and Optimization of Niobium Integrated Matching Circuits

Design of Tuning Circuit of an 850ghz SIS Mixer

A self-pumped high-temperature superconducting Josephson mixer: Modelling and measurement

Characterization of a low-noise superconductor–insulator–superconductor-based microwave amplifier with local oscillator phase-adjusting architecture

Superconducting Integrated Terahertz Spectrometers

Terahertz high-sensitivity SIS mixer based on Nb-AlN-NbN hybrid superconducting tunnel junctions

340 GHz Double-Sideband Mixer Based on Antenna-Coupled High-Temperature Superconducting Josephson Junction

Simulation of the sub-harmonic SIS mixer

Development of an SIS Mixer-Based Low-Noise Amplifier Amenable to Josephson Oscillator Pumping

Development of Superconducting Devices Supporting Radio Astronomy.

Automated design of superconducting circuits and its application to 4-local couplers

Performance Improvements of a Microwave Oscillator Using High Temperature Superconducting Harmonic Mixer

A Tunable 350&#x2013;780 GHz CW Solid State Oscillator of Intrinsic Josephson Junctions in a High-T<inf>c</inf> Superconductor

On-chip superconducting microwave circulator from synthetic rotation

Temperature-dependent Performances of Nb SIS Mixers at Millimeter and Submillimeter Wavelength Microwave and Millimeter Wave Technology

A Novel Mm-Wave SIS Mixer Comprising Series-Connected Junction Array and On-Chip Bias-T