Abstract:Bimetallic catalysts are of great interest because they often display properties that differ from either of their parent metals. Previous studies on the Ni/Pt(111) bimetallic system have shown that the location of Ni atoms in the Pt(111) surface has a strong influence on the electronic and chemical properites of the surface [1]. The bimetallic surface consisting of a monolayer of Ni on top of bulk Pt(111), designated Ni-Pt-Pt(111), binds hydrogen and alkenes much more strongly than either parent metal, resulting in decreased hydrogenation activity. In contrast the surface consisting of a monolayer of Ni atoms in the subsurface region designated as Pt-Ni-Pt(111), has been shown to weaken metal-hydrogen bonds in comparison to Ni-Pt-Pt(111) or either parent metal surface. The resulting abundance of weakly bound hydrogen and alkenes on the Pt-Ni-Pt(111) surface increases its activity for novel low temperature hydrogenation pathways [2, 3]. In a previous attempt to extend these single crystal surface science studies to supported catalysts, PtCo bimetallic catalysts were found to be more active to hydrogenation reactions than PtNi bimetallic catalysts [4]. Therefore this study will focus on PtCo catalysts and the effect of different support materials on catalyst structure and activity. Co and Pt monometallic and PtCo bimetallic catalysts were synthesized and supported on γ-Al 2O 3, SiO 2, TiO 2, and activated carbon (AC). Temperature programmed reduction (TPR) studies were performed to characterize the reduction behavior of the catalysts and to identify suitable reduction conditions. CO chemisorption was used to determine the number of active sites on each catalyst. Flow reactor studies of benzene hydrogenation the series of catalysts were used to compare the activity of PtCo on the different supports. Normalizing the hydrogenation activity with the number of active sites yielded the following trend in activity: SiO 2 → Al 2O 3 → TiO 2 ∼ AC. Activation barriers were also calculated and followed a trend consistent with the normalized activity trend, that is: SiO 2 < Al 2O 3 < TiO 2 ∼ AC. Extended X-ray absorption fine structure (EXAFS) spectroscopy was used to characterize the extent of bimetallic formation. EXAFS analysis found that the SiO 2 and Al 2O 3 supported catalysts showed a greater extent of bimetallic formation (larger Pt-Co coordination number) than either the TiO 2 or AC supported catalysts. Both the TiO 2 and AC supported catalysts possessed large Pt-Pt coordination numbers, suggesting the presence of larger particles. Transmission electron microscopy (TEM) was utilized to characterize the particle sizes. Particles on the SiO 2 supported catalyst appeared to be the smallest and most dispersed, while larger particles were observed in both the TiO 2 and AC supported catalysts.

Activated carbon supported Pt catalysts: effect of support texture and metal precursor on activity of acetone hydrogenation

Nitrogen-doped Mesoporous Carbon Supported Pt Nanoparticles As a Highly Efficient Catalyst for Decarboxylation of Saturated and Unsaturated Fatty Acids to Alkanes

Activity, selectivity and stability of Ni and bimetallic Ni–Pt supported on zeolite Y catalysts for hydrogenation of acetophenone and its substituted derivatives

Support effect on the low-temperature hydrogenation of benzene over PtCo bimetallic catalysts

The Effect of Preparation Method on the Performance of PtSn/Al2O3 Catalysts for Acetic Acid Hydrogenation

Dispersion of Pt Catalysts Supported on Activated Carbon and Their Catalytic Performance in Methylcyclohexane Dehydrogenation

Porous bimetallic Pt-Fe nanocatalysts for highly efficient hydrogenation of acetone

The Role of Carbon Support for Propane Dehydrogenation Over Platinum Catalysts

Properties of Pt/C Catalysts for Hydrochlorination of Acetylene to Vinyl Chloride

The Effect of Sn Content in a Pt/KIT-6 Catalyst Over its Performance in the Dehydrogenation of Propane

High Catalytic Performance and Stability of Pt/C Using Acetic Acid Functionalized Carbon

Effect of microstructures of Pt catalysts supported on carbon nanotubes (CNTs) and activated carbon (AC) for nitrobenzene hydrogenation

Improving activity of Pt supported metal catalysts by changing reduction method of Pt precursor for hydrogen production from biomass

Influence of the metal and of the support on the activity and stability of bifunctional catalysts for toluene hydrogenation

Catalytic Performance of Activated Carbon Supported Pt-Ni Bimetallic Catalyst for Glycerol in Situ Hydrogenolysist

Pt 3 Ti Intermetallic Alloy Formed by Strong Metal–Support Interaction over Pt/TiO 2 for the Selective Hydrogenation of Acetophenone

Synthesis of Mesoporous Pt/Al2o3 Catalysts with High Catalytic Performance for Hydrogenation of Acetophenone

Effect of the supports on catalytic activity of Pd catalysts for liquid-phase hydrodechlorination/hydrogenation reaction

Acrolein Hydrogenation Catalyzed by Pt(111): Effect of Carbonaceous Deposits on Kinetics

Support Effect on the Low-Temperature Hydrogenation of Benzene over PtCo Bimetallic and the Corresponding Monometallic Catalysts

Effects of Pre-Treatment of Supports on Pt/AC Activity