Abstract:Bimetallic catalysts are of great interest because they often display properties that differ from either of their parent metals. Previous studies on the Ni/Pt(111) bimetallic system have shown that the location of Ni atoms in the Pt(111) surface has a strong influence on the electronic and chemical properites of the surface [1]. The bimetallic surface consisting of a monolayer of Ni on top of bulk Pt(111), designated Ni-Pt-Pt(111), binds hydrogen and alkenes much more strongly than either parent metal, resulting in decreased hydrogenation activity. In contrast the surface consisting of a monolayer of Ni atoms in the subsurface region designated as Pt-Ni-Pt(111), has been shown to weaken metal-hydrogen bonds in comparison to Ni-Pt-Pt(111) or either parent metal surface. The resulting abundance of weakly bound hydrogen and alkenes on the Pt-Ni-Pt(111) surface increases its activity for novel low temperature hydrogenation pathways [2, 3]. In a previous attempt to extend these single crystal surface science studies to supported catalysts, PtCo bimetallic catalysts were found to be more active to hydrogenation reactions than PtNi bimetallic catalysts [4]. Therefore this study will focus on PtCo catalysts and the effect of different support materials on catalyst structure and activity. Co and Pt monometallic and PtCo bimetallic catalysts were synthesized and supported on γ-Al 2O 3, SiO 2, TiO 2, and activated carbon (AC). Temperature programmed reduction (TPR) studies were performed to characterize the reduction behavior of the catalysts and to identify suitable reduction conditions. CO chemisorption was used to determine the number of active sites on each catalyst. Flow reactor studies of benzene hydrogenation the series of catalysts were used to compare the activity of PtCo on the different supports. Normalizing the hydrogenation activity with the number of active sites yielded the following trend in activity: SiO 2 → Al 2O 3 → TiO 2 ∼ AC. Activation barriers were also calculated and followed a trend consistent with the normalized activity trend, that is: SiO 2 < Al 2O 3 < TiO 2 ∼ AC. Extended X-ray absorption fine structure (EXAFS) spectroscopy was used to characterize the extent of bimetallic formation. EXAFS analysis found that the SiO 2 and Al 2O 3 supported catalysts showed a greater extent of bimetallic formation (larger Pt-Co coordination number) than either the TiO 2 or AC supported catalysts. Both the TiO 2 and AC supported catalysts possessed large Pt-Pt coordination numbers, suggesting the presence of larger particles. Transmission electron microscopy (TEM) was utilized to characterize the particle sizes. Particles on the SiO 2 supported catalyst appeared to be the smallest and most dispersed, while larger particles were observed in both the TiO 2 and AC supported catalysts.

Pt 3 Ti Intermetallic Alloy Formed by Strong Metal–Support Interaction over Pt/TiO 2 for the Selective Hydrogenation of Acetophenone

Optimizing Alkyne Hydrogenation Performance of Pd on Carbon in Situ Decorated with Oxygen-Deficient TiO2 by Integrating the Reaction and Diffusion

Surface Ir-Ti Alloy Formed via Strong Metal − Support Interaction over Ir/TiO2

Modulation of metal–support interactions in Pt–TiO x synergistic catalysts for propane dehydrogenation

Selective Hydrogenation of Crotonaldehyde over Ir/TiO2 Catalysts: Unraveling the Metal-Support Interface Related Reaction Mechanism

Thermally stable single atom Pt/m-Al2O3 for selective hydrogenation and CO oxidation

Amorphous TiO x Stabilized Intermetallic Pt 3 Ti Nanocatalyst for Methanol Oxidation Reaction

Propane Dehydrogenation over Pt/TiO2–Al2O3 Catalysts

Structural Evolution of Anatase‐Supported Platinum Nanoclusters into a Platinum‐Titanium Intermetallic Containing Platinum Single Atoms for Enhanced Catalytic CO Oxidation

Strong metal-support interactions of TiO2 interface-loaded Pt constructed under different atmospheres for adjusting the hydrogen storage reaction performance of N-ethylcarbazole

Pd/TiO Nanocatalyst with Strong Metal–Support Interaction for Highly Efficient Durable Heterogeneous Hydrogenation

Support effect on the low-temperature hydrogenation of benzene over PtCo bimetallic catalysts

Construction of Ptδ+–O(H)–Ti3+ Species for Efficient Catalytic Production of Hydrogen

Single‐Atom Pt Loaded on MOF‐Derived Porous TiO2 with Maxim‐ized Pt Atom Utilization for Selective Hydrogenation of Halonitro‐benzene

Single-Atom Pt Loaded on MOF-Derived Porous TiO2 with Maxim-ized Pt Atom Utilization for Selective Hydrogenation of Halonitro-benzene

Strong Metal-Support Interactions Between Pt Single Atoms and TiO2.

Porous bimetallic Pt-Fe nanocatalysts for highly efficient hydrogenation of acetone

Influence of Phase Composition of Titania on Catalytic Behavior of Ptco/Tio2 for Benzene Hydrogenation

Single platinum atoms on TiO2 photocatalysts for acetaldehyde oxidation under visible-light irradiation

Alloy strategy to synthesize Pt-early transition metal oxide interfacial catalysts

Enriching Pt 3 ensemble with isolated 3-fold hollow site by crystal-phase engineering of Pt 3 Fe single-nanoparticle for acetylene hydrogenation