Graphene nano-origami using Scanning Tunneling Microscopy

Kim Akius,Jan van Ruitenbeek

DOI: https://doi.org/10.48550/arXiv.1812.09501

2018-12-22

Abstract:Graphene nanopatterning on highly oriented pyrolytic graphite (HOPG) has previously been shown using both atomic force microscopy (AFM) and scanning tunneling microscopy (STM) based techniques, including folding of intrinsic step edges and electrochemical etching or cutting in graphene layers. We here report development of a new technique, combining electrochemical etching and folding using mechanical STM manipulation. Our technique shows unprecedented control of nanoscale folding of graphene in multiple folding steps and could be a route towards STM study of magic angle graphene with in-situ fabricated samples.

Mesoscale and Nanoscale Physics,Other Condensed Matter

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to develop a new technology for nano - scale folding and manipulation of graphene by scanning tunneling microscopy (STM). Specifically, the researchers hope to achieve the following goals:

1. **Precise control of nano - scale folding of graphene**: By combining electrochemical etching and mechanical STM operations, unprecedentedly precise control over the multi - step folding process of graphene is achieved. This helps in preparing graphene samples with specific structures.

2. **Study of magic - angle graphene**: Magic - angle graphene refers to the special physical properties, such as unconventional superconductivity, exhibited when two layers of graphene are twisted at a specific small angle. By in - situ preparation and study of magic - angle graphene using STM, its electronic properties can be deeply understood.

3. **Overcome the incompatibility between traditional preparation methods and STM**: Traditional graphene preparation methods usually involve encapsulating or sandwiching graphene between insulating layers, which is not conducive to STM research. The method proposed in this paper can directly fold graphene on a graphite substrate, thus providing a new approach for STM research.

4. **Explore the applications of other two - dimensional materials**: Besides graphene, this technology can also be applied to other two - dimensional materials (such as bismuth (111) bilayer). These materials face challenges in single - layer preparation, and their potential applications can be explored through STM technology.

### Key Technologies and Methods

- **Combination of electrochemical etching and mechanical STM operations**: A pre - pattern is formed on the graphene surface by applying a high bias voltage, and then mechanical folding is carried out using the STM tip.
- **Multi - step folding and manipulation**: Multiple folding and unfolding operations can be carried out on the same piece of graphene, demonstrating the high controllability and repeatability of this method.
- **Observation of small - angle - twisted moiré patterns**: Small - angle - twisted moiré patterns are observed through STM imaging and fast Fourier transform (FFT) analysis, verifying the number of layers and the angle of the folded graphene.

### Results and Discussion

- **Successful folding of single - layer graphene**: Through STM technology, researchers were able to fold single - layer graphene on an HOPG substrate and observe small - angle - twisted moiré patterns, verifying that the folding angle was approximately 3.5±0.5 degrees.
- **Exploration of the preparation conditions for magic - angle graphene**: It was found that only about 5% of the folds spontaneously formed moiré patterns, indicating that further optimization of the folding conditions is required to achieve more precise angle control.
- **Proposed future research directions**: Including testing the feasibility of this method under low - temperature and ultra - high - vacuum conditions, and exploring the applications of other two - dimensional materials.

In conclusion, this paper aims to develop a new STM technology for precisely folding and manipulating graphene, providing new tools and methods for studying the special physical properties of magic - angle graphene and other two - dimensional materials.