Abstract:The absorber layers in perovskite solar cells possess a high concentration of mobile ion vacancies. These vacancies undertake thermally activated hops between neighboring lattice sites. The mobile vacancy concentration <math> N 0</math> is much higher and the activation energy <math> E A</math> for ion hops is much lower than is seen in most other semiconductors due to the inherent softness of perovskite materials. The timescale at which the internal electric field changes due to ion motion is determined by the vacancy diffusion coefficient <math> D v</math> and is similar to the timescale on which the external bias changes by a significant fraction of the open-circuit voltage at typical scan rates. Therefore, hysteresis is often observed in which the shape of the current–voltage, J–V, characteristic depends on the direction of the voltage sweep. There is also evidence that this defect migration plays a role in degradation. By employing a charge transport model of coupled ion-electron conduction in a perovskite solar cell, we show that <math> E A</math> for the ion species responsible for hysteresis can be obtained directly from measurements of the temperature variation of the scan-rate dependence of the short-circuit current and of the hysteresis factor <math> H</math>. This argument is validated by comparing <math> E A</math> deduced from measured J–V curves for four solar cell structures with density functional theory calculations. In two of these structures, the perovskite is <math> MAPbI 3</math>, where MA is methylammonium, <math> CH 3 NH 3</math>; the hole transport layer (HTL) is spiro (spiro-OMeTAD, 2,2<math> ′</math>,7,7<math> ′</math>- tetrakis[N,N-di(4-methoxyphenyl) amino]-9,9<math> ′</math>-spirobifluorene) and the electron transport layer (ETL) is <math> TiO 2</math> or <math> SnO 2</math>. For the third and fourth structures, the perovskite layer is <math> FAPbI 3</math>, where FA is formamidinium, <math> HC ( NH 2 ) 2</math>, or <math> MAPbBr 3</math>, and in both cases, the HTL is spiro and the ETL is <math> SnO 2</math>. For all four structures, the hole and electron extracting electrodes are Au and fluorine doped tin oxide, respectively. We also use our model to predict how the scan rate dependence of the power conversion efficiency varies with <math> E A</math>, <math> N 0</math>, and parameters determining free charge recombination.

The hysteresis-free behavior of perovskite solar cells from the perspective of the measurement conditions

How measurement protocols influence the dynamic J-V characteristics of perovskite solar cells: Theory and experiment

A Study of Hysteresis in Perovskite Solar Cell

Dynamic electrical behavior of halide perovskite based solar cells

New Insights into the Origin of Hysteresis Behavior in Perovskite Solar Cells

Accelerating the Assessment of Hysteresis in Perovskite Solar Cells

Insights of Hysteresis Behaviors in Perovskite Solar Cells from a Mixed Drift-Diffusion Model Coupled with Recombination

Hysteresis Modeling of Perovskite Solar Cells by an Equivalent Circuit Model

On the Current–Voltage Hysteresis in Perovskite Solar Cells: Dependence on Perovskite Composition and Methods to Remove Hysteresis

On the Origin of Hysteresis in Perovskite Solar Cells

Influences of Dielectric Constant and Scan Rate to Hysteresis Effect in Perovskite Solar Cell: Simulation and Experimental Analyses

Influences of dielectric constant and scan rate on hysteresis effect in perovskite solar cell with simulation and experimental analyses

Hysteresis and Its Correlation to Ionic Defects in Perovskite Solar Cells

Perovskite solar cells: short lifetime and hysteresis behaviour of current–voltage characteristics

Unveiling heterogeneity of hysteresis in perovskite thin films

Investigating physical origin of dominant hysteresis phenomenon in perovskite solar cell

Deducing transport properties of mobile vacancies from perovskite solar cell characteristics

Modulating Hysteresis of Perovskite Solar Cells by a Poling Voltage

Perovskite Solar Cells: Device Construction and I-V Hysteresis

The Influence of Different Recombination Pathways on Hysteresis in Perovskite Solar Cells with Ion Migration

Circuit modeling and analysis of hysteresis effect of perovskite photovoltaic cells