Abstract:We have developed a PET detector module based on sub-millimeter lutetium oxyorthosilicate (LSO) crystal block and prototype Silicon Photomultiplier (SiPM) arrays with additional fast timing output. The LSO array consists of 20×20 crystals of which each pixel is 0.78 × 0.78×3 mm3 and the pitch is 0.8 mm due to the reflector between pixels. The FM SiPM array and FB SiPM array are arranged 4×4 with 4×4mm2 size for each pixel and 0.2mm gap between adjacent pixels. Through dual readout of both fast and standard output signals from this new SiPM, good energy and timing performance can be achieved at the same time. Through multiplexing and summing scheme and charge division resistor network, sixteen channels of fast output and sixteen channels of standard output are reduced to one fast timing signal and four energy signals, making the detector block compact and scalable in building PET scanners. The performance of FM and FB detector module was evaluated. 16×16 LSO crystals were resolved in the flood image and the edge crystals could be identified if a light guide was used. The average energy resolution of FM detector and FB detector were 15.3% ±1.4% and 11.3% ± 0.7%,respectively, at 511 KeV. Through time pick-off method of leading edge discriminator (LED), the average coincidence resolving timing (CRT) of the block against a 3x3x20mm3 coupled with a FB30035 pixel were 401± 10 ps for FM detector and 303 ± 16 ps for FB detector. The average block-to-block CRT were estimated to be 495 ps for FM detector and 324 ps for FB detector. The FB array has demonstrated a better performance due to its much higher PDE at 420nm wavelength than FM array. We conclude that the proposed design is feasible for developing sub-millimeter resolution TOF PET detectors.

Characterization of the demonstrator of the fast silicon monolithic ASIC for the TT-PET project

A monolithic ASIC demonstrator for the Thin Time-of-Flight PET scanner

Test beam measurement of the first prototype of the fast silicon pixel monolithic detector for the TT-PET project

Design and Characteristics of a Multichannel Front-End ASIC Using Current-Mode CSA for Small-Animal PET Imaging.

Characterization of TOF-PET Detectors Based on Monolithic Blocks and ASIC-Readout

Characteristics of a Multichannel Low-Noise Front-End ASIC for CZT-based Small Animal PET Imaging

IMOTEPAD: A mixed-signal 64-channel front-end ASIC for small-animal PET imaging

Development of a Multi-Channel ASIC with Individual Energy and Timing Digitization for SiPM Detectors for TOF-PET Applications

Design of A Monolithic Multi-Channel Front-End Readout Asic for Lyso/Sipm-Based Small-Animal Flat-Panel Pet Imaging

A Novel Sub-Millimeter Resolution Pet Detector with Tof Capability

A Full Functional Monolithic Active Pixel Sensor Prototype for the CEPC Vertex Detector

Time performance of Analog Pixel Test Structures with in-chip operational amplifier implemented in 65 nm CMOS imaging process

Testbeam Characterization of a SiGe BiCMOS Monolithic Silicon Pixel Detector with Internal Gain Layer

Characterisation of a high granularity multi-channel prompt γ-ray detection system prototype for proton range verification based on the PETsys TOFPET2 ASIC

Performance evaluation of the FastIC readout ASIC with emphasis on Cherenkov emission in TOF-PET

Test-beam Performance Results of the FASTPIX Sub-Nanosecond CMOS Pixel Sensor Demonstrator

20 ps Time Resolution with a Fully-Efficient Monolithic Silicon Pixel Detector without Internal Gain Layer

Design of a Monolithic Multichannel Front-End Readout ASIC for PET Imaging Based on Scintillation Crystals Read out by Photodetectors at Both Ends

DIET2: A SiPM Readout ASIC for 10 ps TOF-PET application

An Analog Front-end ASIC Design for 16-Channel SiPM Readout in PET Detectors

DIET: a multi-channel SiPM readout ASIC for TOF-PET with individual energy and timing digitizer