Abstract:Due to the rapid development of the distribution network, there is an urgent need for high-precision state estimation and safe and stable operation, this paper proposes a joint optimal placement method for Phasor Measurement Unit (PMU) and Dual Use Line Relay (DULR) in distribution networks considering fault reconstruction and state estimation accuracy. The proposed method aims to minimize the cost of PMU and DULR configuration. Based on the known pseudo-measurements and Supervisory Control and Data Acquisition (SCADA) measurements, we use the E-optimal standard design of the state estimation error covariance matrix to form the state estimation accuracy index and take the relay protection function of Feeder Terminal Unit (FTU) device and DULR device into consideration of the fault reconstruction. By solving the mixed integer semidefinite programming (MISDP) model, the optimal placement result is obtained, so that the network under normal condition and the network after multiple fault reconstruction can meet the constraints of state estimation accuracy and load loss rate respectively. The proposed method is tested on IEEE 33-node, 123-node systems as an example. The experimental results show that the proposed method is effective and practical. Note to Practitioners— This study is stimulated by the need for optimizing the placement of Micro-PMU (μPMU) in distribution network. Since the new μPMU device DULR has the same relay protection function as FTU, and distributed generation can supply power to the island after failure, this paper adds the load loss rate to the constraint conditions to study the influence of fault reconstruction on the placement scheme. A new two-step SE method considering mixed measurements was used in this paper to improve the computational efficiency of real-time SE of large-scale system while ensuring the accuracy of the calculation results. We have conducted tests in IEEE-33 and IEEE-123 systems. After preliminary verification, compared with the single fault scenario, we find that the placement scheme considering multiple fault scenarios can effectively improve the accuracy of state estimation and reduce the load loss rate of each fault scenario and only increase the cost a little. The increase in the number of DG and contact lines in the network will also effectively improve the feasibility of the placement scheme. The increase of the number of FTU configurations can effectively reduce the configuration of DULR by adding a small amount of μ PMU, reduce the total cost as a result. In future studies, we will further consider the integrated configuration of μ PMU, DULR and FTU, to meet more failure scenarios while reducing costs.

Monitoring & Mitigation of Delayed Voltage Recovery using μPMU Measurements with Reduced Distribution System Model

PMU based Monitoring and Mitigation of Delayed Voltage Recovery using Admittances

Micro Pmu Based Monitoring System For Active Distribution Networks

Joint optimal PMU and DULR placement in distribution network considering fault reconstruction and state estimation accuracy

Enhancing distribution system resilience using micro-phasor measurement units to address unintentional islands following faults

Voltage Control Embedded Resilient Distribution System Restoration Considering Uncertainties

MILP-Based Fault Diagnosis Model in Active Power Distribution Networks

Partitional Collaborative Mitigation Strategy of Distribution Network Harmonics Based on Distributed Model Predictive Control

Wide-area measurement system-based supervision of protection schemes with minimum number of phasor measurement units

Mitigating the Risk of Voltage Collapse Using Statistical Measures From PMU Data

A Fast Load Control System Based on Mobile Distribution-Level Phasor Measurement Unit

Volt-PF Control Mode for Distribution Feeder Voltage Management Under High Penetration of Distributed Energy Resources

Distributed Optimal Conservation Voltage Reduction in Integrated Primary-Secondary Distribution Systems

Distributed Mixed Voltage Angle and Frequency Droop Control of Microgrid Interconnections With Loss of Distribution-PMU Measurements

Graph-based Faulted Line Identification Using Micro-PMU Data in Distribution Systems

Enhancing Indian Practical Distribution System Resilience Through Microgrid Formation and Integration of Distributed Energy Resources Considering Battery Electric Vehicle

Optimizing the allocation of renewable DGs, DSTATCOM, and BESS to mitigate the impact of electric vehicle charging stations on radial distribution systems

Distributed Voltage Security Enhancement Using Measurement-Based Voltage Sensitivities

Optimal Distribution System Restoration with Microgrids and Distributed Generators

Distributed Energy Resource Deployment to Mitigate Adverse Effects of High EV Penetration in Unbalanced Distribution System by Analytical Sensitivity-Based Optimization

Decentralized State Estimation-Based Optimal Integral Model Predictive Control of Voltage and Frequency in the Distribution System Microgrids