Abstract:The design, manufacture and characterisation of an inexpensive, temperature controlled vacuum chamber with millikelvin stability for electrical transport measurements at and near room temperature is reported. A commercially available Peltier device and high-precision temperature controller are used to actively heat and cool the sample space. The system was designed to minimise thermal fluctuations in spintronic and semiconductor transport measurements but the general principle is relevant to a wide range of electrical measurement applications. The main issues overcome are the mounting of a sample with a path of high thermal conductivity through to the Peltier device and the heat-sinking of said Peltier device inside of a vacuum. A copper slug is used as the mount for a sample and a large copper block is used as a thermal feedthrough before a passive heatsink is used to cool this block. The Peltier device provides 20 W of heating and cooling power achieving a maximum range of 30 K below and 40 K above the ambient temperature. The temperature stability is within 5 mK at all set points with even better performance above ambient temperature. A vacuum pressure of 1e-8 hPa is achievable. As a demonstration, we present experimental results from current-induced electrical switching of a CuMnAs thin film. Transport measurements with and without the Peltier control emphasise the importance of a constant temperature in these applications. The thermal lag between the sample space measurement and the sample itself is observed through magnetoresistance values measured during a temperature sweep.

Temperature-dependent transport measurements with Arduino

System of Numeral Temperature Testing Based on ARM and DS18B20

An Arduino Investigation of Newton’s Law of Cooling

Measurement of the Newton's cooling law time-constant by Arduino: an idea for STEM education in High Schools

A low-cost cryogenic temperature measurement system using Arduino microcontroller

Design of a Multichannel Dynamic Temperature Measurement System for Developing Thermal Management System of New Energy Vehicles

Thermally Stable Peltier Controlled Vacuum Chamber for Electrical Transport Measurements

Temperature Measurement on Copper Surfaces for Superconducting Thin Film Cavity Applications

Low-cost and novel Arduino®-Load cell-based prototype to determine transition temperatures

Integrated Electronic Transport and Thermometry at milliKelvin Temperatures and in Strong Magnetic Fields

An Affordable and Customizable Arduino-based Thermo-controller for Thermal Ecology Experiments

A Study on the Effect of Temperature Variations on FPGA-Based Multi-Channel Time-to-Digital Converters

UNCERTAINTY QUANTIFICATION USING THERMOCOUPLE AND ARDUINO® COMPATIBLE HARDWARE

An Arduino-based Low-Cost Hardware for Temperature Control

An Arduino-Based Experimental Setup for Teaching Light Color Mixing, Light Intensity Detection, and Ambient Temperature Sensing

Hassle-free Approach to Thermal Transport Measurements Using Spatial-Temporal Temperature Data

Analysis of experimental conditions for simultaneous measurements of transport and magnetotransport coefficients of high temperature superconductors

Proximity effect thermometer for local temperature measurements on mesoscopic samples

Instrument Design for Digital Thermal Conductivity Measurement.

Primary thermometry triad at 6 mK in mesoscopic circuits

Demonstration experiments for solid state physics using a table top mechanical Stirling refrigerator