Abstract:A high-strength dual alpha+beta phase titanium alloy Ti-6Al-4V is utilized as a material for beam windows in several accelerator target facilities. However, relatively little is known about how material properties of this alloy are affected by high-intensity proton beam irradiation. With plans to upgrade neutrino facilities at J-PARC and Fermilab to over 1 MW beam power, the radiation damage in the window material will reach a few displacements per atom (dpa) per year, significantly above the ~0.3 dpa level of existing data. The RaDIATE collaboration has conducted a high intensity proton beam irradiation of various target and window material specimens at BLIP facility, including a variety of titanium alloys. Post-Irradiation Examination of the specimens in the 1st capsule, irradiated at up to 0.25 dpa, is in progress. Tensile tests in a hot cell at PNNL exhibited a clear signature of radiation hardening and loss of ductility for Ti-6Al-4V, while Ti-3Al-2.5V, with less beta phase, exhibited less severe hardening. Microstructural investigations will follow to study the cause of the difference in tensile behavior between these alloys. High-cycle fatigue (HCF) performance is critical to the lifetime estimation of beam windows exposed to a periodic thermal stress from a pulsed proton beam. The 1st HCF data on irradiated titanium alloys are to be obtained by a conventional bend fatigue test at Fermilab and by an ultrasonic mesoscale fatigue test at Culham Laboratory. Specimens in the 2nd capsule, irradiated at up to ~1 dpa, cover typical titanium alloy grades, including possible radiation-resistant candidates. These systematic studies on the effects of radiation damage of titanium alloys are intended to enable us to predict realistic lifetimes of current beam windows made of Ti-6Al-4V and to extend the lifetime by choosing a more radiation and thermal shock tolerant alloy.

Overview of Fabrication Techniques and Lessons Learned With Accelerator Vacuum Windows

Accelerator Vacuum Windows: A Review of Past Research and a Strategy for the Development of a New Design for Improved Safety and Longevity for Particle Accelerators

Materials adopted for particle beam windows in relevant experimental facilities

Finite Element Analysis for NEG coated vacuum chamber based on ANSYS Workbench

Vacuum for accelerators: introduction to materials and properties

Mechanical and Thermal Analysis of Beryllium Windows for RF Cavities in a Muon Cooling Channel

Evaluation of low-loss alumina material for high-power RF windows

Radiation Damage Studies on Titanium Alloys as High Intensity Proton Accelerator Beam Window Materials

Experimental Study of the Plasma Window

Vacuum Acceptance Tests for Particle Accelerator Equipment

Experimental study of plasma window

Optomechanical Design Considerations for a Vacuum Window for Optical and Infrared Interferometry

Experimental studies of a novel one-dimensional plasma window

Vacuum Window for IBA C18 Twin Cyclotron's Beamline

Numerical Simulation and Experimental Progress on Plasma Window

Investigation and Batch Fabrication of G-Band Broad Band and Low Loss Monocrystalline Diamond Window for Vacuum Electron Devices

Characterization of a plasma window as a membrane free transition between vacuum and high pressure

Theoretical and Experimental Investigation on Magneto-Hydrodynamics of Plasma Window

Design and Fabrication of a Window for the Gas Cherenkov Detector 3.

Ultra thin polymer foil cryogenic window for antiproton deceleration and storage

Fabrication of High Power Microwave Feed Output Window