Abstract:CaMg 2 Bi 2 -based compounds, a kind of the representative compounds of Zintl phases, have uniquely inherent layered structure and hence are considered to be potential thermoelectric materials. Generally, alloying is a traditional and effective way to reduce the lattice thermal conductivity through the mass and strain field fluctuation between host and guest atoms. The cation sites have very few contributions to the band structure around the fermi level; thus, cation substitution may have negligible influence on the electric transport properties. What is more, widespread application of thermoelectric materials not only desires high Z T value but also calls for low-cost and environmentally benign constituent elements. Here, Ba substitution on cation site achieves a sharp reduction in lattice thermal conductivity through enhanced point defects scattering without the obvious sacrifice of high carrier mobility, and thus improves thermoelectric properties. Then, by combining further enhanced phonon scattering caused by isoelectronic substitution of Zn on the Mg site, an extraordinarily low lattice thermal conductivity of 0.51 W m -1 K -1 at 873 K is achieved in (Ca 0.75 Ba 0.25 ) 0.995 Na 0.005 Mg 1.95 Zn 0.05 Bi 1.98 alloy, approaching the amorphous limit. Such maintenance of high mobility and realization of ultralow lattice thermal conductivity synergistically result in broadly improvement of the quality factor β . Finally, a maximum Z T of 1.25 at 873 K and the corresponding Z T a v e up to 0.85 from 300 K to 873 K have been obtained for the same composition, meanwhile possessing temperature independent compatibility factor. To our knowledge, the current Z T a v e exceeds all the reported values in AMg 2 Bi 2 -based compounds so far. Furthermore, the low-cost and environment-friendly characteristic plus excellent thermoelectric performance also make the present Zintl phase CaMg 2 Bi 2 more competitive in practical application.

Significant low lattice thermal conductivity and potential high thermoelectric figure of merit in Na$_2$MgSn

Low Lattice Thermal Conductivity and High Thermoelectric Figure of Merit in Na2MgSn

High Figures Of Merit And Natural Nanostructures In Mg2si0.4sn0.6 Based Thermoelectric Materials

Monolayer SnI2: An Excellent p-Type Thermoelectric Material with Ultralow Lattice Thermal Conductivity

Enhanced Thermoelectric Performance by Strong Phonon Scattering at the Heterogeneous Interfaces of the Mg 2 Sn/Mg 3 Sb 2 High-Content Nanocomposite

Compromising Configurational Entropy Leading to Exceptional Thermoelectric Properties in SnTe‐Based Materials

Thermoelectric performance enhancement of Mg2Sn based solid solutions by band convergence and phonon scattering via Pb and Si/Ge substitution for Sn

Na/Bi-co-doping and Heterogeneous Interfaces Leading to Enhanced Thermoelectric Performance of P-Type Mg3Sb2-based Zintls

Approaching the Minimum Lattice Thermal Conductivity of P-Type SnTe Thermoelectric Materials by Sb and Mg Alloying.

High Thermoelectric Performance and Low Lattice Thermal Conductivity in Lattice-Distorted High-Entropy Semiconductors AgMnSn 1– x Pb x SbTe 4

Atomic-scale structure and thermoelectric properties in medium-entropy PbSnTeSe alloy

Electronic Orbital Alignment and Hierarchical Phonon Scattering Enabling High Thermoelectric Performance P-Type Mg3Sb2 Zintl Compounds

Electronic Orbital Alignment and Hierarchical Phonon Scattering Enabling High Thermoelectric Performance p-Type Mg 3 Sb 2 Zintl Compounds

Low Lattice Thermal Conductivity-Driven Promising Thermoelectric Figure of Merit in NaSrSb and NaBaSb Zintl Phases

Significantly enhanced thermoelectric properties of p-type Mg3Sb2 via co-doping of Na and Zn

Achieving High Thermoelectric Performance in Rare-Earth Element-Free CaMg 2 Bi 2 with High Carrier Mobility and Ultralow Lattice Thermal Conductivity

Entropy and heterogeneous interface engineering promote the low thermal conductivity in SnTe-based thermoelectric materials

Mass and strain field mediated low thermal conductivity for enhanced thermoelectric properties in Zn substituted SnS

Potential thermoelectric materials $\mathrm{CsMI_3}$ (M=Sn and Pb) in perovskite structures from the first-principles calculations

Thermoelectric Performance of Li Doped, P-Type Mg2(Ge,Sn) and Comparison with Mg2(Si,Sn)

First-principles prediction of extraordinary thermoelectric efficiency in superionic Li2SnX3(X=S,Se)