Abstract:With the development of distributed generation and the corresponding importance of the P.V. (photovoltaic) system, it is desired to operate a P.V. system efficiently and reliably. To ensure such an operation, a monitoring system is required to diagnose the health of the system. This paper aims to analyze a P.V. system under various operating conditions to identify parameters-derived from the I-V (current-voltage) characteristics of the P.V. system-that could serve as electrical signatures to various faulty operations and facilitate in devising a monitoring algorithm for the system. A model-based approach has been adopted to represent a P.V. system, using a one-diode model of a practical P.V. cell, developed in MATLAB/Simulink. The modelled system comprises two arrays, while each array has two panels in series. It was simulated for various operating conditions: healthy condition represented by STC (Standard Testing Condition), O.C. (open-circuited), soiling, P.S. (partial-shading), H.S. (panels hotspots) and P.D. (panels degradation) conditions. For the analysis of I-V curves under these conditions, six derived parameters were selected: Vte (equivalent thermal voltage), MCPF (maximum current point factor), Ri (currents ratio), S (slope), and Dv and Di (voltages and currents differences, respectively). Using these parameters, data of the actual system under various conditions were compared with its model-generated data for healthy operating conditions. Thresholds were set for each parameter's value to mark normal operation range. It was observed that almost each considered fault creates a unique combination of sensitive parameters whose values exceeds the pre-defined thresholds, creating an electrical signature that will appear only when the corresponding conditions on the system are achieved. Based on these signatures, an algorithm has been proposed in this study which aims to identify and classify the considered faults. In comparison to other such studies, this work has been focused on those sensitive parameters for faults identification which shows greater sensitivity and contribute more to creation of unique sets of sensitive parameters for considered faults.

Performance Analysis and Fault Diagnosis Method for Concentrator Photovoltaic Modules

Identifying PV Module Mismatch Faults by a Thermography-Based Temperature Distribution Analysis

Performance Assessment of Mismatch Mitigation Methodologies Using Field Data in Solar Photovoltaic Systems

A Fast MPPT-based Anomaly Detection and Accurate Fault Diagnosis Technique for PV Arrays

Experimental analysis and simulation of a production line for CPV modules: impact of defects, misalignments, and binning of receivers

Fault diagnosis of visual faults in photovoltaic modules: A Review

Online Fault Diagnosis, Classification, and Localization in Photovoltaic Systems

A Novel Fault Diagnosis Scheme for PV Plants Based on Real-Time System State Identification

Performance Analysis of Thermal Image Processing-Based Photovoltaic Fault Detection and PV Array Reconfiguration—A Detailed Experimentation

Concentrator Photovoltaic Module Architectures with Capabilities for Capture and Conversion of Full Global Solar Radiation

A fault diagnosis method for photovoltaic module current mismatch based on numerical analysis and statistics

Integrated Model for Comprehensive Performance Investigation of Solar Concentrated Photovoltaic‐Thermal System Embedded with Microchannel Heat Sinks

The Reliability Analysis of PV Panels Installed in KP Region

An IoT and Semi-Supervised Learning-Based Sensorless Technique for Panel Level Solar Photovoltaic Array Fault Diagnosis

Performance Analysis of a Grid-connected High Concentrating Photovoltaic System under Practical Operation Conditions

Reliability analysis of PV array or modules with supercapacitor based measurement techniques

A model-based approach for detecting and identifying faults on the D.C. side of a P.V. system using electrical signatures from I-V characteristics

Fault Diagnosis and Detection Based on Efficiency Loss Test of Photovoltaic Power Station

In-Situ Self-Monitoring of Real-Time Photovoltaic Degradation Only Using Maximum Power Point: the Suns-Vmp Method

Parameter Estimation and Preliminary Fault Diagnosis for Photovoltaic Modules Using a Three-Diode Model

Optimization and performance analysis of a solar concentrated photovoltaic-thermoelectric (CPV-TE) hybrid system